Jump to content
SAU Community

Recommended Posts

Have you fired it up yet

Can't wait to here what this beast will do

Yeah cars been running. Next time I go over ill get a video of it. Hopefully see the dyno before the end of the month and looking like at this stage giving it a test run in November. Not long now.

  • 3 weeks later...
  • 3 weeks later...

Cars going really good. Took it out for a test and tune day last Thursday. Justin from Blacktrack was driving it. Got 3 x 1000ft passes in. 9.1 off the trailer. Followed by 9.0 and 8.8 at 116mph. With a 1.25 60ft. Would of been nice to get a full pass in but the rain put a stop to that. That's also with the car at 28psi and nos only on the transbrake.

3827E56E-C717-4072-AFAE-AD9B75417D1C-492

4D37FB18-9F92-459D-A467-99430784F81C-492

AF126310-9E1F-41D3-9136-B582E4E51F0C-492

746C1A7D-33F4-4E8C-878F-04DABED1F5BA-492

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...