Jump to content
SAU Community

Recommended Posts

There are pros and cons of each, the twins obviously keep a stock look under the engine bay however a single conversion does make any future work on the hot side of the engine bay much easier i.e. cheaper labour wise. No matter your option you will find a set-up that meets your requirements however value for money you can't go past the Garret GT2860R-5s, I PM you with a quote mid last week however only have one set left so if you're interested just let me know and I'll can put them to one side. If you wish to have a chat send me a PM with your mobile number and I'll give you a bell tomorrow.

If you need some factory twin manifolds, let me know. The pair I have are virually brand new.

sorry no complete kit.

as people chime inn you will probably make up the whole kit.

Edited by Stock e-Tune

Yes they are bigger than -5's but doubt you will make 600hp on them unless the rest of your motor is up to scratch. Tbh if ya after 600hp you're better off going the big single path and you might wanna stretch the budget a bit more!

My mobile is fully built standard cams and injectors but I have a power fc and will be upgrading injectors soon to 800cc I have a full exhaust system massive intercooler and pod filters have forged internals and what not I'm thinking -10s cos I can pump out more

I have complete Greddy THRUST TD05's with the option to go to larger TD06 SL2's kit from aircleaners to dumps 76 odd parts to this complete kit still in original boxes...never installed....had the Hi-mount manifold ceramic coated which cost a grand...8k for the kit

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...