Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Sounds good :D

Was thinking today.......qld should put up its own little modifications and maintenance area for tutorials and stuff either in qld or in members section.....

This would be really good for sourcing local knoladge of like what stores you can get certain parts from

And I'm pretty sure a lot of people would like to have a guide close to home and if they know the person just give them a ring if they get stuck

Sounds good :D

Was thinking today.......qld should put up its own little modifications and maintenance area for tutorials and stuff either in qld or in members section.....

This would be really good for sourcing local knoladge of like what stores you can get certain parts from

And I'm pretty sure a lot of people would like to have a guide close to home and if they know the person just give them a ring if they get stuck

not a bad idea Zac.

Like a quick where to guide for parts sourced locally

How's today looking for you? Getting closer to those deadlines?
been efffin hectic.......reviewed everything yesterday with principal and no material changes required which makes me and boss happy (just presentational adjustments) and completed compliance certificates yesterday with the client meeting the banks interest CR which is even better.

Got to work even earlier today because now client is coming this morning to discuss CGT estimates on prospective sale of commercial property that also prepared yesterday and wants additional estimates on the sale of another and I have training at 9:00. So I'm flat out!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Was that with the cas upside or correct way up?
    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
×
×
  • Create New...