Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Nah, I wish I had those kind of skills, a guy in sydney did up a batch for VR4 club members, I just got them back from the ceramic coaters today, only $85 to coat the pair. Good considering the extra 1" of diameter is normally taken up by factory heatshielding

Morning Scottie

Glad to hear you took the 33 out for a spin or spins

hahaha tyres may have been rotating a tad.. Was actually enjoyable to have a drive in it for a change. Havent really overly enjoyed driving it the last few times

hahaha tyres may have been rotating a tad.. Was actually enjoyable to have a drive in it for a change. Havent really overly enjoyed driving it the last few times

don't worry you will get ze poawa back soon mate

11th for me. May wait until that new gov tax thing is online in August though since my tax is very simple.

that is assuming my company gets it right, which may be a stretch since it took them 3 months to transfer over my leave from the old system.

11th for me. May wait until that new gov tax thing is online in August though since my tax is very simple.

that is assuming my company gets it right, which may be a stretch since it took them 3 months to transfer over my leave from the old system.

your old leave does not effect your PAYG Payment summary for last FY Pete.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...