Jump to content
SAU Community

Audio Specialist (Pioneer) Eastern Suburbs


Recommended Posts

Hey guys

Wondering if anyone knows of a good audio specialist that could help me out with some unbearable alternator whine I've got in my front tweeters (Pioneers)?

Cheers

Performance car audio

Bayswater North.

http://www.performancecaraudio.com.au/

My track car sponsor is across the carpark from him (thewheeldeal).

I've tried changing the earthing position but still no difference. I'm not sure what actually happened because it wasn't there before and it only happened recently which I found it to be strange. I might take it in since I'm quite the amateur when it comes to audio setups, but thanks for the tips guys!

more information is required

what headunit?

wired to an amp?

alternator noise can come from the headunit also even if wired to an amp. You can try one of these and are readily available from supercheap/repco etc. It is a noise supressor

alternator%2077.jpg

That's in SE not west lol and if I was going to Autobarn you may aswell shoot yourself in the foot. No offense to your mate dean as not sure if him, but I have fixed too many of dandenongs and narre warrens f**k ups to ever recommend them.

Unsoldered sticky taped wires(not even elec tape)

If Dandenong? Freeway car audio, speak to Steve. They are pedantic about perfection

  • Like 1

I've tried taking the headunit out and the back of it doesn't have the traditional RCA out. It has like this rectangular block of wires that connects to the rca's. I wanted to try and ground the head unit but after taking it out and looking at it, I figured I should just bring it over to a specialist instead.

I'm pretty sure it's alternator whine since it gets louder as my revs get higher lol. Sounds like crazyfrog's sitting next to me rofl.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...