Apexi Power Fc Commander

[_GTR_]

I just bought a Apexi Power FC hand controller and just had a question, Can i just plug it into the ecu and everything will work or do I need to disconnect the battery then connect it?

[Sydneyactionman]

You can plug it straight in & yes everything will work ok but the safe thing to do first is disconnect the neg terminal, turn on the lights to be sure drain off any power then connect thr commander & reconnect the battery.

[_GTR_]

I just connected it and everything works fine with no errors, I just need to have a play with it to get real time stats. It only shows the highest reading it hit e.g. rpm it was at idle 1100 rpm i rev it to 4000 and on the hand controller it just stayed at that, even when the car was back at idle for over a 30 sec.

[89CAL]

its stuck on Max values. If you are in 1,2 or 4 channel then it should show live and max values in little black boxes above the real-time values

If this is the case then it is just stuck on max values. Press up or down and it should go back to real-time. Press all the arrows otherwise, you wont wreck anyhting in monitor mode. The worst you can do is re-set the max values (these are re-set everytime you turn the car off anyway)