Jump to content
SAU Community

**haltech ** E85 Setup**fuel Setup**precision Turbo Kit**engine Package**getrag Conversion**

HKS26T
 Share

Recommended Posts

HKS26T Experienced

HKS26T

Posted
Posted

Hi All,

Due to unforeseen circumstances i will need to move these parts.

1. Haltech platinum Pro r32/r33 plug in; I/o hub, e-flex sensor, wide band lambda, fuel and oil pressure sensors, 4bar map. Not separating at this stage. $3k

2. 1000hp fuel setup; twin ext 044 coming off surge tank. Braided line to Y-piece, Sard fuel rail, ID2000 injectors; includes all dash fittings. Not separating at this stage $1.75k

3. Precision 6262 billet wheel 0.84 rear housing plain bearing, trust divided manifold and wastegate, 4inch custom dump, cat and exhaust to Varex muffler setup. Not separating at this stage. $3.5k

4. Complete Rb26 long motor. Brand new with receipts and warranty from Powertune. JE pistons/argo I beam rods/Arp studs/ Tomei oil pump and gaskets. Head completely serviced to factory spec. Not separating at this stage. $9.5k

5. Expression of interest.. 6speed getrag, Jim berry single full Monty, custom tail shaft for r33 gtr, C's short shifter and titanium gear knob $5.5k

Motor was rebuilt after Pro Fab fcked up and I spun a bearing. Majority of parts have Dyno time only to their name. Parts located in Sydney. Pm for any questions. Can help arrange installation.

Cheers

Steve

  • 2 weeks later...
  • 3 weeks later...
HKS26T Experienced

HKS26T

Posted
  • Author
Posted

Still available

4. Complete Rb26 long motor. Brand new with receipts and warranty from Powertune. JE pistons/argo I beam rods/Arp studs/ Tomei oil pump and gaskets. Head completely serviced to factory spec. Not separating at this stage. $9.5k

5. Expression of interest.. 6speed getrag, Jim berry single full Monty, custom tail shaft for r33 gtr, C's short shifter and titanium gear knob $5.5k

  • Like 1
  • 5 weeks later...
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • GTSBoy
      M35 Aftermarket Fuel Pump

      By GTSBoy · Posted

      My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Dose Pipe Sutututu
      M35 Aftermarket Fuel Pump

      By Dose Pipe Sutututu · Posted

      Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...