Jump to content
SAU Community

Recommended Posts

Hi guys Im in need of some advise please.Went to start the stagea and the battery was flat so I charged it up and when I went to start it again it idled rough and there was no accelerator.Can some one give me an idea of what to do next as I have check the fuel filter on the pump and its clean.

Thanks

Brett

Link to comment
https://www.sau.com.au/forums/topic/438130-stag-dead-in-the-driveway/
Share on other sites

Your right Scotty , I checked the sock but I don't have a check engine light on.I ran a manual MIL check and ended up with 10 slow flashes followed by 3 sets of quick 10 flashes.The car does start but idles good for 3 seconds than idles roughly for a little while than stops.The throttle butterfly is operating.What does AFM stand for and where is it.

Thanks

Bertt

I unplugged the AFM and the car now revs but a little rough so I am about to order a new Bosch one for $80 dollars but why wasn't the engine light on,

Scotty can supply you an AFM at a better price then that. Pm him.

I unplugged the AFM and the car now revs but a little rough so I am about to order a new Bosch one for $80 dollars but why wasn't the engine light on,

Because the AFM was still outputting a signal, and the ecu though it was fine. They don't all blow in the same way, some fail and you need to unplug them to drive, others you can drive home without unplugging. Most throw the MIL though.

Contact me if you have any dramas, the replacement Nissan AFM's are crap and don't last long. Hopefully the one you got is from somewhere else.

Scotty I tried to PM you but the message is blocked.It looks like my supplier for the AFM cant supply for 3 weeks because of Chinese new year so I was wondering if you can supply me with a AFM.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Brooooo Please send ABS control unit schematic Please! R33 gts25t ABS (Its two plug ecu, black and white) wire colors possible? [email protected]
    • Don't even try to run it on the stock ECU if you're going to have the boost controller bring boost above ~10 psi. I've already told you that. If you use the Nistune ECU, you will need to CAREFULLY read the available documentation for Neo tuning, and read some threads on the Nistune forums, to discover the various things you have to do to prevent the ECU from going bananas when the boost is too high. The is a table associated with th boost sensor that must be modified to prevent it from shitting the bed. This is just one of the things that you will need to do to the tune in Nistune, because the Neo turbo ECU will be expecting to see a number of things (such as the TCS) that are not there, and you have to block the DTCs on those. It is totally not surprising to me that you are having the problems that you are, but the solutions to these problems have been known for >15 years. So just get it done.
    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
×
×
  • Create New...