Jump to content
SAU Community

Recommended Posts

Last update before Vietnam...

post-92069-0-03820600-1411190086_thumb.jpg

post-92069-0-73272400-1411190093_thumb.jpg

Brand new door handles! it's safe to say the original ones had faded heaps... So the original owner of the car decided to use a sharpie and colour them in.... Made me lol quite hard.

Took me all of 15 minutes to install. Much better.

  • Like 1
  • 3 weeks later...
  • 4 weeks later...
  • 2 weeks later...

Anthony maaate...I think you need to spend more money!

while it's in the shop grab a quaife front diff and have the rear one tightened up

and you wont regret doing this

It's one of a very few mods that will make you grin and wish you would have done it earlier

  • Like 3

Anthony maaate...I think you need to spend more money!

while it's in the shop grab a quaife front diff and have the rear one tightened up

and you wont regret doing this

It's one of a very few mods that will make you grin and wish you would have done it earlier

this ^^^^^^^^^^^^

Anthony maaate...I think you need to spend more money!

while it's in the shop grab a quaife front diff and have the rear one tightened up

and you wont regret doing this

It's one of a very few mods that will make you grin and wish you would have done it earlier

Ive already been in talks about a front and rear diff. Kesh will be tight for quite a while now though so it may has to wait. But it is on the list. Might do it after Christmas depending.

R is going on the Dyno today or tomorrow apparently. Will believe it when i has it back.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.  
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...