Jump to content
SAU Community

Recommended Posts

So I have had a change in Career path and unfortunately must sell all my R31 turbo parts to fund my studies. All parts are either brand new or close to new condition.

Engine

RB30det, genuine A8 block with forged internals (Aries rods, forged pistons, Very clean engine). Clean reinforced head, N1 Oil pump, Brand new water pump, Immaculate Sump, Rocker cover available as well. Was making 400 hp at the wheels through an auto. When I bought the engine I took it to a renowned workshop in Moorebank, T&D brothers racing. Tony (one of the owners) was going to clean it up for me and prep it to be put in my car. The engine is still at the workshop and can be viewed there. Tony is more than willing to show any potential buyers the engine and talk to them about any components. Contact myself (number at the bottom of add) or Tony directly on 8798 1554 for an inspection.

Price: $2200

Pictures – When I first bought it.

http://i.imgur.com/JGQHcHf.jpg[/img]

http://i.imgur.com/5bXsiry.jpg[/img]

http://i.imgur.com/wunIw18.jpg[/img]

s9ciekZ.jpg

HR 31 shocks, King springs and strut tops

Gas shocks, King springs and Kmac Strut tops, All in good condition. Just the pair.

Price: $200 ono

Pictures

http://i.imgur.com/KOy04n8.jpg[/img]

http://i.imgur.com/0j88Hc5.jpg[/img]

Walbro e85 Fuel Pump

Brand new Walbro High Pressure fuel pump, 450 LPH

Price: $150 ono

Pictures

http://i.imgur.com/TFSn93x.jpg[/img]

XF Throttle Body

Like new Ford XF throttle body, Cleaned and in pristine condition. To suit RB30 forward facing plenum.

Price: $100 ono

Pictures

http://i.imgur.com/hm8jjGQ.jpg[/img]

http://i.imgur.com/Vslc2Vo.jpg[/img]

Custom Forward facing plenum

To suit Vl turbo/ R31 very clean welds and sturdy fabrication job, with fittings welded on. Flange to connect XF throttle body. As seen in pics. Like New condition

Price: $300 ono

Pictures

http://i.imgur.com/ZPEx6LL.jpg[/img]

http://i.imgur.com/1ChPF5k.jpg[/img]

http://i.imgur.com/YG8SkLo.jpg[/img]

http://i.imgur.com/f86Sps6.jpg[/img]

R33 GTST reconditioned gearbox

Reconditioned R33 GTST gearbox. Comes with genuine brand new shifter, These boxes are good for 10 second passes.

Price: $1500 ono

Pictures

http://i.imgur.com/b05AgW0.jpg[/img]

http://i.imgur.com/7Eukd4S.jpg[/img]

http://i.imgur.com/znyKTOW.jpg[/img]

Turbo, wastegate and manifold

Genuine Garrett 35/40, 0.63 rear housing (very clean, no shaft play) on a t3 standard low mount manifold. With a turbosmart 48 progate with screamer pipe attached. Turbo comes with all water and oil lines.

Price: $ 1200 ono

Pictures

http://i.imgur.com/BgjMarY.jpg[/img]

http://i.imgur.com/m9JKzRm.jpg[/img]

http://i.imgur.com/gzrBsra.jpg[/img]

http://i.imgur.com/EwX60YE.jpg[/img]

http://i.imgur.com/u10jAk7.jpg[/img]

Turbosmart FPR 800

Fuel Pressure Regulator

Price: $150 ono

Picture

http://i.imgur.com/Ay45s8H.jpg[/img]

If interested in any parts PM me (first in best dressed) Id prefer pickup, but if parts don’t sell locally I will amend the prices for shipping. But ATM PICKUP ONLY PLEASE!

Parts are advertised on different forums so just ask if sold or not incase i don’t update fast enough.

Please no low ballers/timewasters. Contact number is Zero Four Three Four 210 733. (txt or call)

Located: Chester Hill, Sydney, NSW

Thanks

Michel

  • 3 weeks later...
  • 2 weeks later...
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
×
×
  • Create New...