Jump to content
SAU Community

Recommended Posts

I don't think its fair to talk about twin scroll in light of gains over open, not at all. I believe it is more so a different result than it is an improvement as such.

The twin scroll will definitely bring boost on earlier but will also roll on/off smoother and give an overall more linear feel. Not everyone is into that, Owen's GTX is a good example. He and I had many a PM about that and it was honestly determined that he just wasn't happy with the twin scroll efforts. He much preferred the brute delivery of the open .82

In my own experience I am much the same. Not worried about smooth roll ons and how early it starts to make 'some' power. I am more concerned about how easily accessible power is and how hard it will pull at that point. For that I would say a good open housing will definitely deliver.

  • Like 1

Artz

PM me your address, I'll send you my broken CT12a's after I rip them off the Snoarer, long as you're happy to pay the post

yeah that would be sweet....you broke them? just blown turbines I assume...

have you fixed your boost creep issue with the internal wastegate ?

Never really had boost creep problems, it's a back pressure issue. The exhaust housing I have is a little small for my RB30 with it's ported head, but I'm completely happy with the result I've got.......it's got easily enough HP for a road car (630 4whp) and the response is awesome. I could get more out of it if I changed to the larger housing, but I'm not going to bother.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...