Jump to content
SAU Community

Recommended Posts

Clearing out garage and selling parts from my R33 Skyline

If parts arent listed may still be available, just pm me or send me a msg on 0420923161 and let me know what you are after. I am located in Campbelltown

Passenger Headlight x 2 $150 Each

Pair of Taillights x 2 $90 Each

Doors Both Drivers side and Passenger $75 Each

Boot lid $50

Standard wing series 1 $50

Bootlid + Aftermarket Driftwing $100

Front Strut Brace $70

Crossmember $100

Right Lower Control Arm $70

Left and Right Upper Control Arms $50 Each

Left and Right Hub and Upright $50 Each

Standard Right Caster Rod $20

Power Steering Rack $100

Front Rotors $150

Rear Calilpers $100

Complete Rear cradle with Diff, Calipers, Rotors, Rear Suspension, Handbrake Assembly and Lines $500

Will not separate, only missing right CV Shaft

Aircon Compressor $100

Drivers side Power Window Switch $100

Complete Steering Column With Switches, Ignition Barrel and Key $150

Passenger Seat $20

Back Seat $20

Dash $20

Drivers and Passenger Windows $50 Each

Passenger Power Window Motor and Reg $40

Standard Plenum, Throttle Body, Inlet Manifold and Turbo Manifold $50

4" Stainless steel exhaust from cat back $150

Front Mount Intercooler no piping $150

Front Rio been Chopped to Suit After Market Front Bar $75

Rear Rio $75

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Reading through the engine service manual their advice is do a cylinder balance test. Unplug one injector at a time and see if the idle drops a consistent RPM. You can also do this using a Consult cable which is easier. They also call for unplugging the power transistor, then with the engine off and the fuel rail unhooked from the manifold verifying that you have good fuel flow (even injection, no dripping/leaks, etc) when you twist the CAS by hand. Also verify the spark by pulling the spark plugs and allowing the plugs to ground and turning the CAS by hand. I would also start doing the sensor checks and idle valve checks in service manual. Make sure the MAF tests reasonably, the intake air regulator is sane, etc. You may have to get new spark plugs.
    • This sounds very old of me, however since buying the Tiguan shit box, my view on shit boxes have changed.
    • I've looked up the parts number (41011AL501). It's around $700 OEM. Usually our Infiniti G35 here in Canada have interchangeable parts with my Stagea but the parts number are not the same. I have looked around and it seems the JDM 2005 V35 Skyline (which is the same as our G35) has the same caliper but I cannot confirm. And I can't find a repair kit. The inner brake pads drags on the rotor, seems to be rusty piston. Thanks for the info by the way
    • This coupled with 6-9 speed autos with ridiculously short gearing is why these modern shitbox cars always seem so fast off the line. If it wasn't for those things, Raptors would not seem fast. The problem we have is there is a driveability gap between a more gentle take off and a wheelspinning sideways launch. The difference between ankle flex required to achieve one and ankle flex required to achieve the other is about 0.5°.
    • Yeah I think I'm also with the opposite here. It's 'hard to keep up with traffic' because in the real world I'm accelerating with 15% throttle and they are pinning it. It feels like I'm being an overt dickhead at anything above 15% throttle, so the car sounds like I'm being an overt dickhead to keep up with/get ahead of traffic when I'm really just trying to drive with traffic. There would be no issue 'keeping up with traffic' if we used the same level of throttle input/aggression to drive around. People really do just drive around with their foot nearly pinned in econoboxes.
×
×
  • Create New...