Jump to content
SAU Community

Recommended Posts

Does anyone have or know of an original BL0 R32 GTR in Australia ?

Looks like this

312703_249423025111649_240905932630025_6

Picture courtesy of N1GTR

was discussing this colour with a new friend earlier who is in search of this Unicorn

Thanks

Edited by Sinista32
Link to comment
https://www.sau.com.au/forums/topic/445407-is-there-b-l-0-in-aus/
Share on other sites

ive only seen a photo of one that was in queensland, even had the oem airbag wheel and cruise control if i remember correctly.
also another shell popped up for sale, but it was f**ked.

my sedan is painted this colour.

much amaze in real life.

  • Like 1

ive only seen a photo of one that was in queensland, even had the oem airbag wheel and cruise control if i remember correctly.

also another shell popped up for sale, but it was f**ked.

my sedan is painted this colour.

much amaze in real life.

Pics please ^

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Thanks GTSboy. I will inspect the valves actually, is this something I can do while they are still in the head? The block/bores don’t look bad to be honest hey, I can still see the cross hatches in the bores and they still measure 86.5mm. I’m not sure how to measure the installed ring gaps but I will do that and take it to someone who can. 
    • I’ve had the same headache with my lowered car, scissor jack first then floor jack every time. Ended up grabbing an extra-low profile aluminum jack (about 70mm entry height) and it finally slides under the lip without drama.
    • No sync errors , i have installed AEM disk will return original 360 slot disk and check if there’s any one with running AEM disk could share setup 
    • Its been a while! Finally thought to do something on this car, so here we go. This will be a slow burning, multiple posts as I spend 0.5-1hr a day on this job, over multiple days... Full set of GKTech suspension arms!   Step 1: Buy Arms, done! Step 2: Start removing stuff. HICAS was easy. Rear suspension arms are now gone, they were a bitch but breaker bars with long handle extensions, 2 1.5hr slots later, stock arms are off! Next step, remove the hubs and take them to work to press out the bearings and bushings!  
×
×
  • Create New...