Jump to content
SAU Community

Recommended Posts

i bought the car recently im asuming it was like that when i got it

i did a oil refill few weeks ago & checked now its still full though im pretty scared about the leak

can running high boost be a factor in this?

Edited by KrazyTurk

i did a oil refill few weeks ago & checked now its still full though im pretty scared about the leak

As in a top up or did you do an oil change. Or did you just add 5L of oil without draining the old oil like some less than competent forum members have done in the past?

  • Like 1

As in a top up or did you do an oil change. Or did you just add 5L of oil without draining the old oil like some less than competent forum members have done in the past?

dont see how this would matter

iv got the can replaced now

should i do a leakdown or compression test to be sure?

Huh?

He asked if you drained oil before adding oil. That's a fair question seeing as in the past people have overfilled engines by many litres due to their lack of mechanical ability.

So to be clear. Where is the oil on the dipstick?

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
×
×
  • Create New...