Jump to content
SAU Community

Recommended Posts

Up for sale is my 1993 R32 Gtst 60th Anniversary Edition.

60th Anniversary Edition includes Its own trim of interior, Gtr steering wheel and a very nice rear spoiler

Motor was removed (166xxx) for a major service using all genuine Nissan parts (Have receipts).

Work that was completed.
•Timming belt kit
•Rb25 water pump (better flow)
•Thermostat
•Rocker cover seals
•Injectors cleaned and pressure tested
•Air con re gassed and working
•New Exeedy Heavy duty clutch
•Hicas lock bar and all lines removed
•RB25 Neo Turbo OP6 only had (70,000)
•3" Turbo back exhaust not loud nice note, tucked up well so car is over 100mm of the ground
•R33 GTST front brakes with Trw Lucas pads all round.
•All fluids replaced. Engine, gearbox, diff, brakes.
•R33 Lower control arms (increase In camber)
•Drift teks 17X8 and 17x9 Potenza re002 up front and ATR sports on rear

I planned to keep this car for a very long time and made it as reliable as possible. The next thing on the list was to repaint the car as it does have a little bit of fade on the roof (pictured) and some scratches. Although paint is good for its age I was wanted it perfect.

Car will be sold without RWC as I don’t have the time but it’s a very clean car and won’t require much if anything any inspection is welcome, Has rego untill 17/01/2015 Genuine inquires only and no swaps thank you

$7,500
0422155233
south east Melbourne

post-78115-0-76408400-1410664806_thumb.jpg

post-78115-0-75819500-1410664807_thumb.jpg

post-78115-0-70951900-1410664808_thumb.jpg

post-78115-0-49291400-1410664809_thumb.jpg

post-78115-0-34727600-1410664810_thumb.jpg

post-78115-0-13515500-1410664811_thumb.jpg

post-78115-0-17875500-1410664812_thumb.jpg

Edited by elinaki31
Link to comment
https://www.sau.com.au/forums/topic/448607-1993-r32-gtst-60th-anniversary-7500/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...