Jump to content
SAU Community

Hay

Humbla

By Humbla,
in New South Wales

 Share

Recommended Posts

Calsonic14U Mentor

Calsonic14U

Posted
Posted

I hate the drive accross the Hay plains, but have done it 4 times within 12 months lol. The sheep sheering station is a good spot for lunch. Make sure you fill your tank b4 leaving hay if heading to SA lol

Link to comment
https://www.sau.com.au/forums/topic/449467-hay/#findComment-7403313
Share on other sites
Humbla Grand Master

Humbla

Posted
  • Author
Posted

Aaaahh "tornado": predecessor to the roundabout!

Going to Mildura then Genelle?

Not sure it's in our area terry,but I would like to go there.

Been around the riverina this time it's beautiful out here long paddocks of green and gold. :-)

Link to comment
https://www.sau.com.au/forums/topic/449467-hay/#findComment-7403859
Share on other sites
Calsonic14U Mentor

Calsonic14U

Posted
Posted

Yah ill drive the Sydney to Adelaide route again one day. Last time i did the 17.5 hour drive in 1 go with only petrol stops. On the way home from Adelaide 8 months later i did the same trip and went home through Bathurst. Even after 13 hours of driving i took the time to detour and take a fully loaded R33 packed with all my stuff around the track haha.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/449467-hay/#findComment-7404698
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Dose Pipe Sutututu
      What brakes on R34 GTT(Europe)

      By Dose Pipe Sutututu · Posted

      Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • soviet_merlin
      WGNC34 - floor mats

      By soviet_merlin · Posted

      Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...