Jump to content
SAU Community

Recommended Posts

Hello all,

I have scored another 32moredoor gts4(scored it mega cheap...), when I bought it the engine had been played with.
Has had FFP and topmount td06-20g-external gate installed, fmic, stock injectors, stock coilpacks, stock afm(green label), stock ecu(still untuned after installs).
I have seen the car running before all installs and it was mint.

Has also had alarm/immobiliser and switch to disengage the front diff installed (have herd of immobiliser screwing with some cars)

On cold start I have to feed it to get it to start and idle which it only just does, once running it struggles to run, misses like crazy(sounds like a rough subaru) and overfuels(can smell it) sits on about 500rpm then stalls out.

Ecu is telling me code 43 but I have had multimeter on the TPS wiring and all is good voltage wise but nothing changes when its running and I disconnect the plugs on the side. Has been swapped out for a known working tps and same problem.

Didnt think a turbo and plenum swap would throw everything out so much???
Blows a bit of white smoke which im guessing is fuel.
Havent kept it alive long enough to get warm incase its something major.

All the coilpacks are fine and plugs seem to be ok aswell, swapped out ignitor and no change

Also there is NO change in idle etc when I unplug the AAC etc...

I have looked into most things and am about to send it to a shop but would rather save the $$$ for when I get nistune/afm/injectors/TUNE but dont want to do all that and find out the motor is ROOTED!!!!

I attached a before and after of the engine, did a massive tidy up/clean while trying to find the root of the problem, has all new vac lines etc now. Can upload a video of it trying to run if that may help.

post-116531-0-74971200-1413098241_thumb.jpg

post-116531-0-45967000-1413098439_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/449625-rb20det-help-please/
Share on other sites

unfortunately for you, running aftermarket turbos on the factory ecu can make the engine grenade on boost. I would suggest a comp test at the minimum.

Check AFM wiring, and maybe for vac leaks. Although a vac leak usually leads to a high and lean idle.

white smoke is usually a bad indication but it could have been condensation in the exhaust if the engine hasn't fully warmed up yet.

note; if you do a comp test don't forget a wet test as well to get an idea of the piston ring condition

So did the car get hammered with the new stuff on it or just started and it was running crap?

As Blackkers said if it got a hard time with the new turbo etc it would have easily killed the engine.

Coming from an sr20 background I have been lookign at the pvc and aac scraching my head actually.....looking at all the treads about these and they just make me scrach my head more lol....

I have a broken hand atm so having trouble pulling it apart so havent gotten to taking the pvc out

The whole plenum set up has me scraching my head actually. Been wondering if having ALL vac lines for wastegate etc coming straight out of the plenum might be confusing the ecu a bit? not currently running a bov so no vac in cooler piping only the 3 coming out of the plenum as you can see in pics....

had a little tinker before and pulled aac off and cleaned it (was sooo full of carbon) then set the idle on the side of that which had it running a bee's d!ck better

Your pcv setup won't be helping.

^^^ Agree, is there even a PCV valve there? looks just like a fitting then hose to rocker cover. Will be sucking un metered air.

You mean the fitting on the firefall side of the ffp?

Edited by Noddy42

You mean the fitting on the firefall side of the ffp?

I think they might be concerned by the open breathers on the cam covers.

If you are from an SR20 background, then setting up the various connections on an FFP on an RB should be simply a case of making them look and do what they do on an SR. Same things have to go the same places.

I think they might be concerned by the open breathers on the cam covers.

If you are from an SR20 background, then setting up the various connections on an FFP on an RB should be simply a case of making them look and do what they do on an SR. Same things have to go the same places.

Thats easy enough then, should be all good.

Will block them all bar one and see what that does

Your pcv setup won't be helping.

^^^ Agree, is there even a PCV valve there? looks just like a fitting then hose to rocker cover. Will be sucking un metered air.

You guys where spot on, the pvc valve is still in the stock plenum and thats just a open fitting...... going to change it now. Cheers guys

By the way. It's PCV, not PVC. PVC is a type of plastic.

LOL sorry.... to much pvc at work.

PCV was some of the problem, noticable differance, now it starts/turns over and stalls straight away, I can baby it at 1000rpm but as soon as foot comes off it stalls. WAY WAY less fuel smell now but a hint still there.

Thanks shitloads guys,

still getting the error code 43/tps wiring tho.... anyone know of anything else that would cause that to come up? voltages for the tps seem sweet as and has been swapped for known working one.

Whoever did the plumbing of the all vac lines & breather lines should be revoked of his man hood and grow a vagina..

You need to plumb back OR block the PCV line going back into the plenum as the car is still running an AFM.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well, I can recommend the partial AV system translation CD I ordered from Car Audio Workshop in NZ. Whilst it didn't address the date issue, it has conveniently translated on-screen menu items into English, and now allows the GPS-received time to be offset in hours rather than minutes, so I can display Eastern Australian time accurately ( and bump it by another hour when daylight savings starts ).
    • Yuh, if it's 45°C outside, my car is driving in it.
    • I'd be curious to hear more. Otherwise, have you driven a modern x-trail? I wonder how it compares. Here in Australia they are/were popular for rentals and fleet vehicles. I have been in some and my impression was they are bad. But, this may have been very different in the 2000s at a good trim level. Twenty years is plenty of time to make the model worse. I do very much agree with the 2 silver cars in the garage approach. But, not driving because it's too hot would not leave a lot of time in the year for many Australians. I don't think you need to worry too much unless the car has actual issues with overheating. 
    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
×
×
  • Create New...