Jump to content
SAU Community

Recommended Posts

Hey guys sadly I need to part with a project thats gone no where in the last few years.

1996 r33 gtst bought when it had 60k in 2003 now has over 80k on the clock. The car had a full respray (retained black colour) in 2007 and has been garaged since.

The car is cheap because it is missing an engine and gearbox. Everything else is in good condition

Gtr rear wing, 400r side skirts, cf bonnet, 3 inch exhaust. R32 gtst rims are on the car at present

Car is located in Albury NSW.

$2500 no offers.

Phone or sms 0416294030 or email [email protected]

Cheers

Justin

Link to comment
https://www.sau.com.au/forums/topic/451674-cheap-r33-gtst/
Share on other sites

Yep just havent gotten round to head south and take some yet. Im sure most will know what a black s2 gtst looks like

This assumes all black S2s are in the same condition...

Link to comment
https://www.sau.com.au/forums/topic/451674-cheap-r33-gtst/#findComment-7443360
Share on other sites

  • 2 weeks later...
  • 2 weeks later...
  • 1 month later...
  • 2 weeks later...
  • 3 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
×
×
  • Create New...