Jump to content
SAU Community

Recommended Posts

Skyline update.... total loss however, i brought it back for 1000bucks [emoji3] plan is to strip it down and assess the damage underneath. If its ok, il rebuild it from the ground up [emoji48]


Great price!!
  • Like 2
Skyline update.... total loss however, i brought it back for 1000bucks [emoji3] plan is to strip it down and assess the damage underneath. If its ok, il rebuild it from the ground up [emoji48]

$1000 bargain. We could start playing fish. Have you got a? Yep $1000. Have you got a yep $1000. What did the insurance pay out?

$1000 bargain. We could start playing fish. Have you got a? Yep $1000. Have you got a yep $1000. What did the insurance pay out?

Would a new k frame fix the damage? Or is it more substantial underneath?
11 minutes ago, Beyond Blue R33 said:


Would a new k frame fix the damage? Or is it more substantial underneath?

Main damage is radiator suport and bumper rio. Was gonna get a new front bumper and carbon bonnet anyways. 

  • Like 1
When the 1.3bar rule cam in nissan moved into multiple cylinder tuning.  Each cylinder had its own fuel and ignition trim. So when they had it all figured out they actualy made nore horsepower than they did befor lol and for the endurance races they knocked the boost back to 1bar. They could safley get 4000 racing kms out of there rb26 @ 800hp in the early 90s.....most of the time they ran in rwd only but in the wet they actualy configured it to run 60/40 front bias to gelp pull the car out of the corner instead of pushing it out. 
P.s, ur dad sounds like a legend!

Man those Gibson motor sport 32s are the stuff of legend. The one Richards/Skaife drove in 92 was up for sale recently. Came with 6 spare engines and boxes. Serious buyers only. (lotto win).
  • Like 1



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...