Jump to content
SAU Community

Recommended Posts

Hey guys, so I've been having some issues with my 07 V36 350GT Sedan for awhile now. The issues are on and off but now its present every day and it's starting to annoy the shit out of me.

1) At cold start / first drive for the day, when driven, the car would stutter (where RPM fluctuates and you can feel the car bucking). This issue is now present every time I drive if the car has been left to cool down. Initially I thought it was a vacuum issue but found no vacuum leaks.

There were talks about transmission issues and even engine oil issues in 350/370z forums but I am not sure if this is it.

2) Lately when I start the car, cranking it talking longer, some days it tries to crank, while rpm is v low it starts popping a few times. Stepping on the accelerator tends to get the crank going.

This lead me to think it's fuel pump, injector or coil packs not working properly.

I get no error codes whatsoever and am at my wits end. My mechanic said maybe try replacing the fuel pump first and go from there. OEM pumps looks to cost around $650 and up. Not sure if I'm looking at the right thing.

Would love some opinion re the issues but also opinions on if I should get OEM fuel pumps or look at after market ones?

Link to comment
https://www.sau.com.au/forums/topic/463132-fuel-pump-injector-coil-pack-issues/
Share on other sites

Might be a bit of a long shot, but have you been able to monitor the battery voltage from a cold start?

I had an issue on my wife's J31 Maxima a few years back where it would be hard to start sometimes and then splutter for the first 5sec or so after firing. After that it ran fine.

Turned out the battery voltage was low due to a lot of short trips (wife works about 3km from home), and it wouldn't run properly until the engine RPM was high enough to allow the alternator to supply the correct voltage. After taking the car for a long drive, it would be fine for a few weeks.

We just make sure it gets a reasonable drive on the weekends now and it hasn't been an issue since.

Also explains why the car eats batteries every 2 years or so.

Edited by sonicii

Hmm, I did think of that, since initially the first issue did not happen all the time but I do about 350km to 400kms per week with half of that done on the weekend. I will check again on this though. Thanks for the suggestion....keep em coming!

For the first point in the OP, it only happens in first few min of driving.

Edited by colin.ssc

To stop the engine stuttering with a cold engine, try running Castrol Edge 0w40 oil. Worked 100% for me! (I had engine stuttering with both Castrol Edge 5w40 and Mobile 1 0w40 - the only other oils I have used in the vq35hr) The theory has something to do with oil density switching the VVT on just a bit to early ie during the 2-3 minute warm up mark. These engines aren't supposed to use VVT until xxx operating temperature, and are apparently fussy on oil choice. I personally also recommend OEM filters (get them from Nissan for the 350/370z) to ensure flow rates and relief valve pressures are correct.

Anyway there is a massive mamojam thread over here:

http://my350z.com/forum/maintenance-and-repair/307878-sputtering-during-warm-up-32.html

As for your slow engine cranking - I'd think battery first and starter motor second.

I'd like to hear what works out for you eventually!

Edited by Rufus007

Thanks, will give that a try and battery! Will update as I go.

Be sure to do one at a time so you know what fixed it.

And if you need a new pump forget about the OEM unit you can get a better one cheaper from Scotty:

  • Like 2

Could be the pump or fuel filter, but more likely the spark plugs, or just water in the IPDM, that's where I would start.

Faults like this can get expensive if a mechanic is involved, especially if he hasn't worked on VQ's much.

Could be the pump or fuel filter, but more likely the spark plugs, or just water in the IPDM, that's where I would start.

Faults like this can get expensive if a mechanic is involved, especially if he hasn't worked on VQ's much.

How do we treat for water in IPDM? And can you PM me re fuel pumps or filters? Heard you make em?

This comment is spot on - change one thing at a time. I'd still like to know what works for you in the end, mostly because I once had the same issue from your description (sorted now though).

<p>

Be sure to do one at a time so you know what fixed it.

And if you need a new pump forget about the OEM unit you can get a better one cheaper from Scotty:

That looks very mild. Mine is alot worse. 0w30 indeed helps, stuttering nearly gone but still a little. I guess maybe it is the VTC issue? Will do more testing over the months (when I find more time).

Ordered a fuel pump from Scotty, hopefully that solves the cranking issues.

When it gets bad, it's very very bad, like something is breaking, so yes I will look into it. I've read that thread before just never bothered and thought about it too much / didnt think that was the issue as the VTC's don't turn on til it's hot enough...who knows. Annoying AF!

Castrol Edge 0w30

Starting fine as in I had issues at cranking. On the stuttering issue - the stuttering is still there, very mild, quite delayed. I think (just my opinion) that the stuttering is happening on a certain temperature. Because of the 0w, this temp is achieved at a later time and because by that time I am already driving a longer distance without braking or letting off the throttle, I don't experience the stuttering.

Before this service the stuttering can only be felt if and when I accelerate / accelerate after letting to go of throttle (around the estate areas) etc if that makes any sense.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • By popular demand.. it was a coil. Got my hands on 1 new OEM coil, replaced with the one that made the less noise difference when I unplugged it while the car was running and started the car up. No stutter and the engine light was gone. I guess I’ll buy the other 5 they have lol
    • No, code 21 is very straightforward. It can only be the things described in that diagnostic flow. In fact it has no way of knowing that the spark plug resistance is out of spec.
    • Hi, SteveL Thank you very much for your reply, you seem to be the only person on the net who has come up with a definitive answer for which I am grateful. The "Leak" was more by way of wet bubbles when the pedal was depressed hard by a buddy while trying to gey a decent pedal when bleeding the system having fitted the rebuilt BM50 back in the car, which now makes perfect sense. A bit of a shame having just rebuilt my BM50, I did not touch the proportioning valve side of things, the BM50 was leaking from the primary piston seal and fluid was running down the the Brake booster hence the need to rebuild, I had never noticed any fluid leaking from that hole previously it only started when I refitted it to the car. The brake lines in the photo are "Kunifer" which is a Copper/Nickel alloy brake pipe, but are only the ones I use to bench bleed Master cylinders, they are perfectly legal to use on vehicles here in the UK, however the lines on the car are PVF coated steel. Thanks again for clearing this up for me, a purchase of a new BMC appears to be on the cards, I have been looking at various options in case my BM50 was not repairable and have looked at the HFM BM57 which I understand is manufactured in Australia.  
    • Well the install is officially done. Filled with fluid and bled it today, but didn't get a chance to take it on a test drive. I'll throw some final pics of the lines and whatnot but you can definitely install a DMAX rack in an R33 with pretty minor mods. I think the only other thing I had to do that isn't documented here is grind a bit of the larger banjo fitting to get it to clear since the banjos are grouped much tighter on the DMAX rack. Also the dust boots from a R33 do not fit either fyi, so if you end up doing this install for whatever reason you'll need to grab those too. One caveat with buying the S15 dust boots however is that the clamps are too small to fit on the R33 inner tie rod since they're much thicker so keep the old clamps around. The boots also twist a bit when adjusting toe but it's not a big deal. No issues or leaks so far, steering feels good and it looks like there's a bit more lock now than I had before. Getting an alignment on Saturday so I'll see how it feels then but seems like it'll be good to go       
×
×
  • Create New...