Jump to content
SAU Community

Recommended Posts

basically i bought a hole bunch of goodies, one of which is a gtr plenum, where putting a spacer plate between my head and the plenum to match the studs etc, was wondering if this would bring on results as good or better than the greddy plenum for the rb25? I heard the gtr plenum has fins that guide the air into each cylinder as the greddy one doesnt. can anyone confirm this? I also got gtr fuel rail, injectors,reg and pump too. amongst lots of others

Link to comment
https://www.sau.com.au/forums/topic/47046-gtr-intake-plenum-on-rb25/
Share on other sites

  • Replies 101
  • Created
  • Last Reply

Top Posters In This Topic

If you have already got the plenum, why don't you actually have a look at it to see if what you heard about it is true?

Also might want to search on this, there was a long thread on this topic a few months ago with pics of both plenums, and how they looked mounted up to the head.

  • 1 month later...

Greaddy being the big company they are, I’m sure with out a doubt they have invested lots of time and research to get the best performance out of a RB25 plenum they why they made one for an RB25 and one for an RB26 because each motor has slightly difference workings.

Your best bet would be to sell the GTR plenum and invest in a RB25 Greaddy one if you really are that keen to change.

Yes Steve, but how do I get multiple throttles onto a Greddy plenum for my Rb25? Either way I'm going to have to do some fab. And I know the GTR plenum works well as a unit. Not sure about the capacity of the Greddy ones either. My car isn't being built for outright power but more so for low down torque/boost response.

Thank you for your opinion Steve. However I want multiple throttles and a front facing plenum that is not too large in capacity. Going for the Rb25 plenum and single throttle will reduce my throttle response not to mention the extra intercooler piping.

Oh and it doesn't matter what you are doing - you have to look good doing it.

Trust me - it will work and work fine. You can tune the car to suit so I am not worried. I have heard flow test results from both plenums and I'll take the GTR one thanks.

Have you ever heard of a GTR plenum flowing unevenly? No I don't think so.

Q for Steve - Yes Zoom magazine found that it lost power in most areas, but can you tell me how that RB20 test applies to my motor? 3lt with modified cylinder head and GT35 0.82 housing? I'll give you a hint - there is no comparison.

i dont think that an rb20 comparison would even be accurate to the rb25. Afew more cc's to play with on the 25 so hopefully it should work alittle better than the results of the rb20 one, however i still dont know anything about the results of the rb20 rb26 plenum thing.

I am with you lukevl, I am also planning on doing this to my RB25 in the next 6months and am not doubting that there will be an increase in the flow. I would almost put money on it and say that the GTR surge tank flows equaly if not more then the Greddy surge. The individual throttle bodies are also good for around a 1000hp, so you wont have to be worring about upgrading to a bigger single throttle body. Also I would rather spend $250 rather then $700+ on the greddy. When do you plan on doing this?.....I was going to make an adapter plate also, and wouldn't mind seeing how yours turns out.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to it's full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so damn hot in there, that made it all the more easy to remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. I was standing there looking at the car and said 'f**k it'. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...