Jump to content
SAU Community

Mad Mundy

Mad Mundy
 Share

Recommended Posts

Mad Mundy Rookie

Mad Mundy

Posted
Posted
Mad Mundy

Hi ppls, hope to find some advise on which lump would be best ? I have a HR31 and the engine is not that healthy. So it requires a transplant. I'm looking to have around 400hp. It is a manual ATM however it needs to be converted to auto as I'm in a wheelchair.

I don't want to spend six months building this or that as I build bikes and have too many projects already. So I bolt up would be the ideal result.

Any help I'd appreciate.

/;-$

Link to comment
https://www.sau.com.au/forums/topic/471115-mad-mundy/
Share on other sites
KiwiRS4T Grand Master

KiwiRS4T

Posted
Posted

If you don't want a project you should be able to pick up an RB30DET already built. Price will depend on specification but a cheap build with stock pistons should be able to make 300RWKW without too much trouble.

Link to comment
https://www.sau.com.au/forums/topic/471115-mad-mundy/#findComment-7838323
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • Murray_Calavera
      MAJOR FUEL ISSUES 25det neo r32

      By Murray_Calavera · Posted

      Post picks of your hanger and pump setup as I have above. 
    • 25debt
      MAJOR FUEL ISSUES 25det neo r32

      By 25debt · Posted

      bumping this post as im still having dramas, my fuel pick up is sitting on the bottom of the tank, my pump gets a constant 13 volts through a relay, my fuel pressure holds consistently without fluttering or dropping, yet as soon as im near half a tank of fuel my car starts fuel starving and leaning out, it cant be due to g force as it never pulls hard enough before it starts breaking up, any help would be much appreciated 
    • Dose Pipe Sutututu
      Starter motor replacment teeth count.

      By Dose Pipe Sutututu · Posted

      Just a thought, was that car and auto at any point of its life? If so, maybe whoever bridged the inhibitor switch/circuit did a not so good job.
    • Dose Pipe Sutututu
      Dose's Sometimes DIY and Pay Someone Home & Boat Improvement Thread

      By Dose Pipe Sutututu · Posted

      Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • Kinkstaah
      Strange issue RB25DET wont start

      By Kinkstaah · Posted

      I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
×
×
  • Create New...