Jump to content
SAU Community

Recommended Posts

Brake Disc + Pads for my 07 V36 Skyline

Hey guys,

So my daily is due for its major service and one of the things that was listed is I need to change the brake discs.

I was just wondering what are my options out there.

I don't race my car, nor do I race in streets, I just use it from A to B. So I don't need high performance discs/pads.

I also don't want to fork out over $1k for OEM.

My car is a sedan btw.

Try Brakes Direct in QLD.

Brakes that fit V36 sedan with single piston calipers.

They have the front and rear discs plus pads. Can do OEM or something a bit better.

3 hours ago, magellows said:

I was looking at eBay, it seems like they have a lot for v35, but I'm assuming it won't work with my v36??

The V35 brakes are completely different... The 3.5 and early 3.7 V36 sedan has a weird sized huge (330mm) single piston brakes that were not used on many other Nissan's.  From MY 2010 they were replaced with a slightly smaller (320mm) and thinner disc, with dual piston calipers. These smaller brakes are much more common.

Really no point trying to economise on the brakes when they are so important, and not even really that expensive for the slightly upgraded parts.

These are the brakes you are looking for....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes, I know🙄 but the sequential is not in my budget... don't want to reduce power neither, so looks like I'm stuck in the rabbit hole🤣
    • You’ll be very upset when you bust that too not to mention the gearing totally sucks. Don’t do it.
    • Is the panel filter one that is oiled? Have you ever cleaned or touched the AFM?
    • So.... the K&N air box thingo was too big, ended up gifting it to a mate, well, by gifting it he actually supplied food and beer at the pub,  which was nice, as it will not sit on a shelf in the garage for the next 10 years I did trim up some of the existing stuff to neaten it all up and gave it some wrinkle paint, unfortunately it currently has a used and abused mish mash of different types of hose clamps, 4 big fat T bolt type (shit), and a few normal clamps of vairing sizes and brands, but..... only until the 6 constant tension black worm clamps that I ordered from EFI solutions turn up next week Currently the current hose clamps are triggering me hard, LOL Is this the final version, probably not, I really want just 2 silicone pieces, a straight bit of silicone from the filter to the MAF is easy and will happen as soon as I head into Just Jap tomorrow, the problematic part is a 30° silicone bend from the MAF to the TB that I can connect the engine breather from the head, I found that there are bulk head fittings for boat bilge pumps that should work, but until I can get a 30° silicone bend the alloy pipe, and the 11ty thousand hose clamps, are there for the foreseeable future 4 hose clamps are golden, 6 are grudgingly acceptable, the 8 currently holding it all together is just taking the piss    I've also ordered 60 more retaining wall blocks for the front yard, I mis-gonculated the height that was required to get above the base of the Photinia's (red robin's) that are the hedge behind the front fence, currently it is 2 blocks high, and about 1/2 a block short, so going 3 blocks high will be above the base of the red robin's, and allow some room for mulch
×
×
  • Create New...