Jump to content
SAU Community

Recommended Posts

Hey guys just wondering if anybody has had a low fuel pressure problem? My v35 was sitting for a couple of months waiting for a new clutch after it was all installed i cranked it over and it started fine but instantly started idling rough revd do op to 500 and almost stalls, there is little to no throttle response and will stall if you dont pump the accelerater to try get the revs up? Has anyone had any similar issues?

Link to comment
https://www.sau.com.au/forums/topic/475533-v35-issue/
Share on other sites

When it first ran bad it threw two codes for the vvt solenoids we cleared it and it came back straight away i bought new ones and codes are gone speaking with a couple of my mates they sugested a couple of things that it could be a mechanic friend said it sounded like a blocked exhaust but we unbolted it and didnt change anything also low oil pressure was suggested we checked it last week and pressure seemed normal except it would rise and drop with the revs when it was about to die. Then it was brought up that it might be starving for fuel and without trying to rig up the oil pressure guage to the fuel line i cant tell if it is, so i was turning to the forum i get most of my answers from for advise ??

and i havent cleaned out throttle body yet

Link to comment
https://www.sau.com.au/forums/topic/475533-v35-issue/#findComment-7892846
Share on other sites

Well im just seeing if anyone has some advise for anything i can check to cross off the list, trying to avoid the mechanics but if its too hard to pinpoint ill take it in. Ive looked through alot of threads and havent seen anything with the same symptoms as mine. I know it might be annoying to tell people the same shit but if anyone has anything i can try i would appreciate the advice ?

Link to comment
https://www.sau.com.au/forums/topic/475533-v35-issue/#findComment-7892922
Share on other sites

The usual list is:

  • Dirty fuel injector(s)
  • Fouled/worn spark plugs
  • Faulty coils
  • Dirty IACV
  • Dirty/stuffed AFM (including dirty sensor element, dry/cracked solder joints, bad loom pin connections)
  • Bad CAS loom pin connections
  • Dying fuel pump or FPCM

And to that there is a random selection of other possible shit, like the O2 sensor can cause wierdnesses, the fuel pressure reg could just possibly be stuck open, and so on.

Link to comment
https://www.sau.com.au/forums/topic/475533-v35-issue/#findComment-7892941
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...