Jump to content
SAU Community

R32 GTR doesn’t want to run

BaysideBlue32
 Share

Recommended Posts

BaysideBlue32 Rookie

BaysideBlue32

Posted
Posted (edited)

So I’ve had my R32 GTR for a little over a week and have been driving no problem. I was driving around today and stopped and got gas and drove off with still no issues. I got to my last stop and shit the car off and was gone for maybe 10 minutes. Come back, turn the key and let the fuel pump prime and go to start her up. She rough idled for about 5 seconds before dying, now she will turn over and die instantly. I’m pretty lost on what the issue could be. Also a relay in the trunk by the tail lights  clicks ever 10 or 15 seconds when the key is turned to accessory. 

Edited by BaysideBlue32
Link to comment
https://www.sau.com.au/forums/topic/478411-r32-gtr-doesn%E2%80%99t-want-to-run/
Share on other sites
Duncan Grand Master

Duncan

Posted
Posted

When you say 'it turns over and dies instantly' I guess you mean it does start at least momentarily, rather than just turning over and not starting?

Starting with the relay, there are 2 in the boot, either side of the lock. The larger one is for 4wd and is often the cause of regular clicking, which is generally a problem with the accumulator needing to be recharged or replaced.  The smaller relay (either green or blue, can't remember) is the fuel pump relay.

It sounds to me like a fuel supply problem and the most obvious reason is being our of petrol. If not I'd get a multi meter onto the fuel pump terminals to make sure there is battery voltage for the first 3 seconds when someone turns the key to IGN. That should confirm there is power where there should be which would say dead fuel pump. Otherwise if there is no power there, there is some electrical issue so you'd look at relays, fuses to the fuel pump

BaysideBlue32 Rookie

BaysideBlue32

Posted
  • Author
Posted
11 minutes ago, Duncan said:

When you say 'it turns over and dies instantly' I guess you mean it does start at least momentarily, rather than just turning over and not starting?

Starting with the relay, there are 2 in the boot, either side of the lock. The larger one is for 4wd and is often the cause of regular clicking, which is generally a problem with the accumulator needing to be recharged or replaced.  The smaller relay (either green or blue, can't remember) is the fuel pump relay.

It sounds to me like a fuel supply problem and the most obvious reason is being our of petrol. If not I'd get a multi meter onto the fuel pump terminals to make sure there is battery voltage for the first 3 seconds when someone turns the key to IGN. That should confirm there is power where there should be which would say dead fuel pump. Otherwise if there is no power there, there is some electrical issue so you'd look at relays, fuses to the fuel pump

Yea the green relay in the boot is the one clicking. I’m leaning more toward fuel being the issue. Just not sure to start with the pump or the relay

BaysideBlue32 Rookie

BaysideBlue32

Posted
  • Author
Posted
18 hours ago, Duncan said:

Well....check under the bonnet for a green relay you can live without for a moment and swap it into the boot....

UPDATE: So I just let the car sit for a few hours and now she starts up. But the engine seems to be struggling in lower Rpm’s but does fine in higher revs around when boost starts to kick in.

KiwiRS4T Grand Master

KiwiRS4T

Posted
Posted

Pull the fuel line off the rail and see what happens when you turn the key. Could be blocked filters or as Duncan says pump on the way out (or coils or CAS or lots of things but start with the fuel supply).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MissMintyR33
      R33 persistent issues. P/steering and lag/misfire

      By MissMintyR33 · Posted

      I thought that might be the case, thats what I'll start saving for. Thanks for the info 
    • jtha7
      Strange issue RB25DET wont start

      By jtha7 · Posted

      Ps i found the below forum and it seems to be the same scenario Im dealing with. Going to check my ECU coolant temp wire tomorrow    From NICOclub forum: s1 RB25det flooding at start up Thu Apr 11, 2013 7:23 am I am completely lost on this. Car ran perfectly fine when I parked it at the end of the year. I took the engine out and painted the engine bay, and put a fuel cell with an inline walbro 255 instead of the in tank unit I had last year. After reinstalling everything, the engine floods when the fuel pump primes. if i pull the fuel pump fuse it'll start, and as soon as I put the fuse back in it starts running ridiculously rich. I checked the tps voltage, and its fine. Cleaned the maf as it had some dust from sitting on a shelf all winter, fuel pressure is correct while running, but wont fire until there is less than 5psi in the lines. The fuel lines are run correctly. I have found a few threads with the same problem but no actual explanation of what fixed it, the threads just ended. Any help would be appreciated. Rb25det s1 walbro255 fuel pump nismo fpr holset hx35 turbo fmic 3" exhaust freddy intake manifold q45tb q45 maf   Re: s1 RB25det flooding at start up Fri Apr 12, 2013 5:07 am No, I didn't. I found the problem though. There was a break in one of the ecu coolant temp sensor wires. Once it was repaired it fired right up with no problems. I would have never thought a non working coolant temp sensor would have caused such an issue.
    • jtha7
      Strange issue RB25DET wont start

      By jtha7 · Posted

      Hi sorry late reply I didnt get a chance to take any pics (my mechanics on the other side of the city) but the plugs were fouled from being too rich. I noticed the MAF wasn't genuine, so I replaced it with a genuine green label unit. I also swapped in a different ignitor, but the issue remains. I've narrowed it down a bit now: - If I unplug and reconnect the fuel lines and install fresh spark plugs, the car starts right up and runs perfectly. Took it around the block with no issues - As soon as I shut it off and try to restart, it won't start again - Fuel pressure while cranking is steady around 40 psi, injectors have good spray, return line is clear, and the FPR vacuum is working. It just seems like it's getting flooded after the first start I unplugged coolant sensors to see if its related to ECU flooding but that didnt make a difference. Im thinking its related to this because this issue only started happening after fixing coolant leaks and replacing the bottom part of the stock manifolds coolant pipe. My mechanic took off the inlet to get to get to do these repairs. My mechanics actually just an old mate who's retired now so ill be taking it to a different mechanic who i know has exp with RBs to see if they find anything. If you have any ideas please send em lll give it a try. Ive tried other things like swapping the injectors, fuel rail, different fuel pressure regs, different ignitor, spark plugs, comp test and MAF but the same issue persists.
    • GTSBoy
      Freddy Plenum vs Genuine options RB25

      By GTSBoy · Posted

      My return flow is custom and puts the return behind the reo, instead of at the bottom. All my core is in the air flow, rather than losing some of it up behind the reo. I realise that the core really acts more as a spiky heatsink than as a constant rate heat exchanger, and that therefore size is important.... but mine fits everything I needed and wanted without having to cut anything, and that's worth something too. And there won't be a hot patch of core up behind the reo after every hit, releasing heat back into the intake air.
    • Murray_Calavera
      R33 persistent issues. P/steering and lag/misfire

      By Murray_Calavera · Posted

      There is a really fun solution to this problem, buy a Haltech (or ECU of your choice) and put the MAF in the bin.  I'm assuming your going to want more power in future, so you'll need to get the ECU at some stage. I'd put the new MAF money towards the new ECU. 
×
×
  • Create New...