Jump to content
SAU Community

Recommended Posts

Hey, im having an issue with my rb20det before 4k revs it felt very boggy and then after 4k revs it felt fine till 6k then it felt like it had no power

it has a 25det gearbox and a r34 neo turbo fmic 3inch exhuast

 

ive tried to turn boost up and down didnt do anything ive also tried resetting timing and the timing was off but now its set but its become worse where if it gets any boost at all if just boggs down

 

have no idea what this could be or what to even look up any help is appreciated

Just now, wildeagle44 said:

Could be a boost leak or it might be pulling timing. Have you checked for fault codes?

havent checked for fault codes as dont have the right reader for r32 dont think its a boost leak as boost doesnt fall off or anything

R32 ECU diagnostic can be triggered with a screwdriver or a paper clip. Read all about it.

It will be a boost leak, or a dying fuel pump as #1 suspects.

After that, it is absolutely everything else in the engine bay. all the usual suspects. read all about it.

Just now, GTSBoy said:

R32 ECU diagnostic can be triggered with a screwdriver or a paper clip. Read all about it.

It will be a boost leak, or a dying fuel pump as #1 suspects.

After that, it is absolutely everything else in the engine bay. all the usual suspects. read all about it.

yeah i suspect fuel pump or the regulator, i was told to block off the regulator return and see if problem still happens

5 minutes ago, GTSBoy said:

No. Put a fuel pressure gauge on it and drive it under load. This is proper diagnosis, not half-baled diagnosis. If the pressure doesn't do what it is supposed to do, then you blame the pump. Your reg is very unlikely to be crook.

alright ill try do that, i just did a ecu diagnostics and got code 34 which is knock sensor 

Just now, GTSBoy said:

Bypass knock sensor with (500k resistor - I think. Look it up, it's findable). If the knock sensor is crook and it's running on the knock map, it will feel doughy. This should make it feel better. Then you  just buy a new one.

I just had a look and I actually have no knock sensor loom at all, both knock sensors are there just no loom, going to borrow a friends and see if that fixes my issues. Have never had a check engine light tho but its always had this issue since I owned the car so its never had knock sensor loom.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • Yeah, I am super excited for this.
    • Was the car running before he touched the car?
×
×
  • Create New...