Jump to content
SAU Community

Recommended Posts

There is a pair of wires that runs from the back of the stereo/amplifier to the speaker. One of these will be disconnected in some way. Broken wire, broken solder joint, broken connector. Or, the speaker could have shat itself. The voice coil inside is made up of really fine wire and will die under too much power input, or from age, or from getting wet, etc etc.

6 minutes ago, GTSBoy said:

There is a pair of wires that runs from the back of the stereo/amplifier to the speaker. One of these will be disconnected in some way. Broken wire, broken solder joint, broken connector. Or, the speaker could have shat itself. The voice coil inside is made up of really fine wire and will die under too much power input, or from age, or from getting wet, etc etc.

i’ll have a look. thanks mate

13 minutes ago, GTSBoy said:

There is a pair of wires that runs from the back of the stereo/amplifier to the speaker. One of these will be disconnected in some way. Broken wire, broken solder joint, broken connector. Or, the speaker could have shat itself. The voice coil inside is made up of really fine wire and will die under too much power input, or from age, or from getting wet, etc etc.

if the speaker is still going just a lot quieter than the other side, has it got to be the wire?

Could be. Could be that you accidentally adjusted the balance to the left. Could be that the amplifier module has shat itself.

Could be a rat died in the door, and its carcass is pressed up against the back of the speaker cone stopping it from moving as much.

7 minutes ago, GTSBoy said:

Could be. Could be that you accidentally adjusted the balance to the left. Could be that the amplifier module has shat itself.

Could be a rat died in the door, and its carcass is pressed up against the back of the speaker cone stopping it from moving as much.

Any way i can test the amp module?

When I say "amp module", I mean an integrated circuit on a circuit board either in your head unit or in a separate amplifier. I have no idea what sort of car, or what sort of stereo is in it. Doesn't really matter, there is little that you could do to test such a thing.

At this point, you should do what you should have done from the start. Take the door apart and have a look. Consider swapping the speakers from left to right to see whether the problem stays put or follows the speaker. It might even just go away if it was a loose connection.

Failing that, get someone who know about wires to have a physical look at it, in person.

  • Like 1
36 minutes ago, GTSBoy said:

When I say "amp module", I mean an integrated circuit on a circuit board either in your head unit or in a separate amplifier. I have no idea what sort of car, or what sort of stereo is in it. Doesn't really matter, there is little that you could do to test such a thing.

At this point, you should do what you should have done from the start. Take the door apart and have a look. Consider swapping the speakers from left to right to see whether the problem stays put or follows the speaker. It might even just go away if it was a loose connection.

Failing that, get someone who know about wires to have a physical look at it, in person.

thank you

That last bit of advice from GTSBoy is solid. It's a lot easier to work with your doors than it will be to take apart your dash and then the stereo. Swap the speakers around. If the problem follows the speaker, bad speaker. That would be the most likely place to start, especially if you like to crank that very average sound system (in my opinion) that these cars have.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Apologies for the long post, but needed somewhere to lay out the entire timeline of events and actions taken:   I've got an 89 GTR with a R34 RB in it. It's been running great all year, driven probably 500KM in the last month. It's not my daily driver, just a weekend fun car.    Build info: R34 RB26 - HKS 2.7 stroker kit, HKS adjustable cam gears, HKS turbo upgrades, Trust intercooler, R34 factory DENSO 440cc injectors, JUN chipped/tuned R32 ECU. All of this work was performed in Japan back in 2019.    Thursday 10/2/25 - It's a nice day and decided I'll drive it to work, I start it up in the garage and I notice it took a few extra cranks and sounded a bit funny. I figure maybe it was just because it was a pretty chilly morning. I pull it out into the driveway to warm up a bit before leaving. As I leave the driveway, it feels very off and sounds like a misfire. I pull it back in the garage to deal with after work and take the daily to work. I was able to diagnose it as a cylinder 5 misfire with the old spark plug test (unplugging each plug until a sound change with the engine running). I take off the whole ignition system, ignitor, plugs, spark. *Important note, it is still on the R32 ignition system with the separate ignitor system. I test each system with a multi-meter and nothing presents as a smoking gun. I put it all back together and it starts up no issue. I go ahead and order the PRP R35 ignition conversion kit. It should arrive today (10/13/25)   Friday 10/3/25 - Another nice day, car starts up great and drives great all day. Very pleased that everything seems to be OK   Sunday 10/5/25 - Decided I'll take it to play some golf, load up and drive to the course about 25 minutes away. Drives wonderful the whole way there, I pull in the parking lot and the engine completely comes to a stop. I do not recall if it sputtered at all, but just remember all of the sudden the engine was off. I roll it into a parking spot, try to crank it back on and nothing.  It'll crank and crank and not even try to start. End up getting it towed back to my house and push it up into the garage.    Items I have checked: Fuel in the tank Fuel Pump relay Fuel pump fuse  Spark Plugs & gap Coil packs Ignitor    I know the cylinders are getting fuel as the plugs smell like fuel after a start attempt. I tried spraying starter fluid into the manifold and cranking and not even a sputter.    I decided to do the live CAS test (removing the the CAS, ignition on and spinning the CAS stalk to see if the injectors pulse and spark is active). All of the injectors were pulsing and I have spark at the plug. The half-moon end of the CAS did seem very loose, I'm not sure how much play is supposed to be there, but it was more than I expected. There was no in/out play of the shaft, just the tip end that is pinned on had quite a bit of play.    CAS Play video   When I put the CAS back in, I stupidly did not re-time the engine. I know I need to do that tonight, however, I do not think it will start given it seemingly was not the issue. My plan is to do the PRP R35 coil kit and retime the engine at the same time.    I plan on ordering the Haltech Nexus Plug-in ECU once they are available again, but ideally would like to get this sorted before firing the parts cannon at it and potentially adding more variables.    Anything glaring that I am missing here, I'm a bit at a loss?          
    • Get it on a dyno. Get something logging Consult. Run it up and find out what is causing it.
    • Looking for a plenum for rb25 de+t neo  Not looking to push much power maybe 300kw at the wheels, is there much difference in flow for Freddy “Greddy style” compared to original Greddy or options like Proflow or Otaku garage?    I won’t be porting the de Neo head for now as I think it’ll be fine 280-300rwkw but appreciate the help and any experiences anyone has between them and any advice. Thanks  Looking at this plenum for now below 
    • engine wise almost no mods: stock ecu Greddy front mount intercooler Greddy forward facing intake w R33 TB stock fuel system, stock injectors, rail etc. Kakimoto racing hyper 3 inch exhaust system Apexi intake filter New NGK –R BCPRES (.8 gap) plugs  
    • Nice one @Pac - looks like a fair few 1600's there! 
×
×
  • Create New...