Jump to content
SAU Community

Recommended Posts

I installed a Hybrid Front Mount intercooler and had to remove a piece of the factory intercooler plumbing where the hose from my bleed valve was connected.

where can I plumb this line into now? as the new hybrid kit has no where to plumb it to i have heard you can connect it to the carbon cannister line does this work?

Are you talking about the Blow off valve?  Your Bleed valve should be located between the actuator and the turbo........not on your intercooler plumbing
yes i know but on a r33 there is a t piece which goes to the intercooler piping as well as actuator and the turbo. does anyone know where i can plumb the bleed valve?

hey i have installed this kit on my skyline and i went to autobarn and got a screw in brass fitting. once you screw it in it has the nipple on it like the factory piping to put the pipe onto.

see images

also see my gallery for install pics.

yeah i bought the fitting for $4 or so, drilled a hole a little smaller than i needed then got the right size tap and tapped the hole then screwed in the fiting with a little plumbers tape. it works a treat and has done for almost 10 months now.

i have played a little also and found that a restrictor in this pipe as in the factory one shown makes the power seem to come on better when used with a manual boost controller as before it would spike and cause the ignition timing to retard.

just an idea, seemed to work on my car anyway?

Ive just tee'd mine into the fuel pressure reg line for the moment, its what it says to do in the Trust VSPL intercooler kit instructions.

Anyone who has bought an AVCR will have a spare metal nipple which is perfect to screw into the intercooler piping after you drill a hole in it.

Has thread and is the perfect size for it.

I plann on doing this the next time i take the cooler piping off, as i want the shortest hose possible from the piping to boost controller

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • No those pads are DBA too  but they have colors too. I look at the and imo the green "street" are the best.
    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
×
×
  • Create New...