Jump to content
SAU Community

Recommended Posts

i think it really depends how you drive the car...if you thrash it, i would say yes. it just lets the turbo cool down. but its not that neccessary to have one. you could always just sit in the car for like 30 seconds then switch off. its really up to the individual.

Provided you take it easy in the last 5 minutes of driving before you turn the car off, then a timer isn't really needed.

If it was, it would be installed by the factory.

Just don't thrash the car before you turn it off.

joel, you set the turbo timer for the length of time you want the engine to run on idle, so that the engine doesnt go straight from being hot-as to suddenly cool, which damages the internals cause of the sudden temp drop. i think you're thinking about boost controllers mate.

IMO turbo timer are overkill for street use. For everyday use, if you slow down and take it gently the last few minutes before arriving at your destination, you won't really need turbo timer that much.

Only when you take your car to the track regularly, it will be quite handy when you have to lock the car and walk away between lap sessions.

My understanding of the need for cool down is to prevent coking/carbonising of the oil in the turbo bearings, which can occur if you shutdown while everything is still hot. If you keep it running on idle for a short while (or driving low load as Sky031 suggested), then the turbo has a chance to cool down, lots of fresh oil is circulated through the bearings and the oil left sitting there when you shutdown won't carbonise. Carbonising of the oil will stuff your bearings.

All a turbo-timer does for you is automate the cool down, so you don't have to sit there. Personally, I drive low load and/or sit there for a minute or two or keep it running while I get my bag out of the boot and stuff.

As for locking and leaving at a track day - who the hell is going to pinch it?!! I left it running with bonnet up and doors open ....

Cheers.:)

As for locking and leaving at a track day - who the hell is going to pinch it?!!  I left it running with bonnet up and doors open ....

Dunno where u normally go for track days, but I've seen certain tracks with open entrance to public (no security standing there) and anyone can just walk in and pinch anything from the pits when no one's looking... Some other tracks are good as they have one or two controlled entrance in/out of the pit area.

it is illegal in vic to have a turbo timer as it violates adr standards. your engine must not run when the keys are removed, this is an adr rule and a turbo timer bypasses this rule completely hence it being illegal. the purpose of it as stated is to let the engine run, while the engine is running the turbo is still spinning and has oil and water running through its water/oil lines. as soon as you kill power to the engine those lines stop flowing so the turbo halts and is most likely very hot.

with the use of the turbo timer it gets a chance to idle for a minute or two

most manauls for turbo cars suggest this and the r33 at least did have a factory turbo timer option its on the left of the sterring column down about 30cms, usually its a blank panel but on some r33s its a switch with short and long and the turbo symbol. i prefer the fact to leave it idle for a minute or two as it gives a chance for all the temps and shit (if high) to settle, at least a tiny bit

I recently read an editors reply from speed magizine from a similar question.

He said that they are a waste of money that are often incorrectly installed which leads to the fuel pump still pumping petrol out if you have a major accident. They exponse ignition wires that makes the time to steal your car dramatically less. He went on to say that anyone that doesn't take it easy 5 minutes before parking a their car doesn't deserve to have a turbo car.

Dunno where u normally go for track days, but I've seen certain tracks with open entrance to public (no security standing there) and anyone can just walk in and pinch anything from the pits when no one's looking... Some other tracks are good as they have one or two controlled entrance in/out of the pit area.

Sorry, mate. I am living in my own little world and ignoring the realities of life in places less fortunate than Perth. If you ever get the chance to cross the Nullarbor, you would enjoy a track day at Wanneroo or Collie, I am sure.

Meanwhile, life way out West seems to have other benefits compared to good ol' Victoria, judging from comments in this and other threads about their application of the ADRs. The disparity between states for relatively straightforward rules seems farcical. If the ADRs said that all cars had to have a round steering wheel with two to four spokes covered in a non-slip grip, I reckon the state rules would be something like:

NSW: RTA would say cars had to have steering wheels and cops would defect you based on your age and who's in the car.

Vic: You could have either two or four spokes or three spokes with a leather grip, but not two or four spokes with leather grip, unless it was a factory option.

WA: You could fit an aftermarket steering wheel as long as it was not smaller than the factory wheel, but cops would still defect you if you were not white caucasian or if they were having a hard time with their missus.

QLD: You could fit an aftermarket steering wheel, as long as it was yellow suede to match the seats.

SA: Any steering wheels are fine, as long as they say "Holden" in the middle.

NT: Whatever looks cool when your fingers are gripping it really tight!

Cheers.

Mate got fined, at the servo, standing outside his car, leaning on it, with it running wiating for it to cool down... undercover cop car pulls up next to him, 'heres a fine for have the car running unatended'

of course it was a skyline ...

he was seriously leaning on the car while it was running waiting for it to cool down heh

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Short answer: No. Medium answer: No, because you still need to conjure the things out of thin air to bolt them to a NA to make it a NA+T. Long Answer: No - The things you need to conjure - meaning a turbo, intercooling, manifolds, exhaust, intake/manifold/piping, clutch, injectors, fuel pump, AFM (?), ECU + Wiring (woo, N/A loom fun) have to come from somewhere. You could have many scavenged these things from an OEM car that someone had upgraded from and use some of these. This will be cost prohibitive now, especially so in the USA. You'd probably pay the same for newer, upgraded components that are better than old OEM stuff from 25-30 years ago. None of these big ticket items are re-usable for the N/A car. Why not buy new and upgrade while you're there? The only real consideration is turbo and fuel sizing and determining whether you want to stay within the bounds of the OEM engine or get into rebuild territory. These limits ARE lower with a N/A motor and especially N/A gearbox at the starting point. And if you're gonna upgrade those then you may as well consider having them built to begin with. Because everyone here knows you're never far from that next engine rebuild once you start making the power you want... The cars you see on the internet and SAU etc have been built over decades. If you're really clued in... you would sell your US car to somebody for what you paid for it. You would then scour AU JDM pages or SAU and buy a car like Dose's on this forum with your powerful American Dollar. This will save you so much money in the long term. Importing it could be tricky. Or it might not because USA. I have long said the only reason 90's Japanese stuff took off was because a) Japanese people had Japanese cars so that is what they used b) Australians could import these cars to Australia with very minimal changes and use them on the road here c) Neither country had well-priced access to US or EU Sports Cars. I don't believe the JDM scene would have taken off in Australia at all if we had EU priced EU BMW M offerings, or more especially the AUS V8 Scene would never have existed if we had the multitude of US cars like Camaros, Mustangs, Corvettes at the prices you folks do. After all - Do the math. I would say put a V8 in your R34 and that's the smart way forward. It is. I did it. I know this from my own experience. But at that point there's no reason to simply not buy a C5 or C6? It would be simpler and easier and cheaper and bette-
    • Reading all this... hurts lol. I have an ENR34 5MT and I paid an inflated USA price for the car alone, had to do tons of preventative maintenance past that, and so I'm over $30K USD into the car already and haven't even touched power.  I wanted to +t it. Not even trying to make GTR numbers, I'd be happy with 250hp.  Can I get away with paying much less to make that happen?
    • Damn you’ve done well, definitely snapping necks.
    • Great weekend and event. Open fire at the caravan park, perfect weather all day and a great feed and a couple of drinks at at awesome country pub.
    • Waaay ahead of ya....(evil laugh!!) Will show the fitment and spec details later when it isnt as rainy !
×
×
  • Create New...