Jump to content
SAU Community

Recommended Posts

I'm just wondering who's out there with a 20 putting out this kind of power. I've seen them every now and again, but it would be nice to have a collection in the same thread.

If you do... post up and let us know your spec list! If you are in the mid 200+rwkw range... go ahead and post up as well. If you have a dyno graph... please post it since it would be nice to see how these mods affect the power band.

No slicks (some 17 inch tyres which cost me 10 bucks each) 2.0 60 foot

Was just a hi flow vg30 turbo (v trim), fmic, gtr fuel pump, and mines map ecu and a bit of boost around 1 bar.

Was dynoed at around 290 but probably had a little more on the night 310-320 rwhp that is

i got 333 HP @ wheels ..

rb20det in a 180sx

hks t04e kit

ems 8860

gtr injectors

bosch 044 fuel pump  

etc

havent run it yet , no rego sitting in my garage lol

Sounds good! Nice to see some other S13's with RB's SXC and CS... especially putting out some very respectable power! What's the powerband like with that T04E? I'd be interested to see what cams would do for you...

Sounds good!  Nice to see some other S13's with RB's

Not an rb20.. But an rb S13 none the less.

93 S13.

94 rb25 taken out to 2.6lt.

Custom twin turbo set up using 25/30's.

Plus other mods.

best time of 10.8 @ 127mph in the middle of the day in silly heat. Around 600hp @ the wheels on C16.

Pics in my gallery. Shoot me a PM, and I can scan the mag write up when I get time.

Cheers, Josh.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hi. This is just my curiosity because iam sure the tuner figure something out...but either way i want to ask. The "problem" is that the Nistune ECU (Stagea FW and RB25DET NEO from Stagea) sees many times the speed than the speedo does(he says the speedo show 120 km/h - correct speed and the ECU shows like 510km/h ) I told him that this car/tranny getting speed from rear diff. If iam not mistaken the RB25DET NEO "need" to see tranny speed sensor? (my tranny has the plug for it). So couple of "question" If he connects/wire the speed sensor to the tranny...are the signals gonna intervene and if...what if he disconnects the rear diff one and the speedo stops working? Or the "new" sensor from the tranny "take over" and will not going need the one from diff? As i said i know he figure/get that done...iam just curious to know what are the solutions 🙂 
    • Your IACV is set to idle too low. You need to adjust it via the screw Duncan mentioned. From memory it should be 650rpm with the valve electrics unplugged. What is it trying to idle at with the IACV plugged in?
    • Ahhh, I need the whole head unit. I definitely needed to roll back through and review your setup, ha ha! Neat setup they have going on. I just need a full double din head unit. But I want good and responsive. I might have to review what the likes of pioneer have out these days.
    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
×
×
  • Create New...