Jump to content
SAU Community

Recommended Posts

Hey all,

A mate of mine and i were discussing the other day, Nitrous oxide.

He was telling me that you can run a 50 shot of nitrous and it can be beneficial to ure engine (as it cools down the pistons a bit aswell as the rest), rather than destroy it.

Im pondering possibly doing this to my own car... but would like some opinions first. Has anyone here got a nitrous setup in their car? running stock internals etc? Does anyone know roughly how much it would cost to get installed?

All info/opinions appreciated :(

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/
Share on other sites

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Hey, coulda told you this before but I think I forgot to. Seen a stock Ti R31 running 50 shots down the drags with complete stock internals. He claims to have done 54 passes at that point with it and it didn't miss a beat. Got some nice low 14s which is good considering there normally people trying to pull a high 15 in stock form!

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/#findComment-1151585
Share on other sites

NOS is the "SHIT"! :)

I run an 80hp wet shot & the HIT is better than Viagra!

When set up propperly is is a safe & effective hp gain , tho getting it right can be an absolute BIATCH..... as those who were present at my first effort will testify.

As a result of this.....only a WET shot is worth doing (wet shot is where the correct ammount of fuel is injected with the nos).

I use Geogre at ADRENALINE for all Nos related stuff.... he's seen it all.

Go the Gas :burnout:

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/#findComment-1151729
Share on other sites

good to hear rep003,

so how much for somthing like this? do you still find it to be safe? I have always wanted to put it on but everyone always seems to say oh but this can go wrong and that can go wrong.

Plus not too mention the pic i saw recently were the whole engine blew up of the drag car when the lines caught fire! the whole bonnet flew off!!

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/#findComment-1151789
Share on other sites

MirKz, i was once into nos as i through it was cheap hp, if you look at the nos website they have different setup for different power lvls, i belived anything over 300hp they requirment you run forged internals.

i belived rev210, uses it in his car, and i think it was something like 100shot and he had good results also

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/#findComment-1151915
Share on other sites

good to hear rep003,

so how much for somthing like this? do you still find it to be safe? I have always wanted to put it on but everyone always seems to say oh but this can go wrong and that can go wrong.

Plus not too mention the pic i saw recently were the whole engine blew up of the drag car when the lines caught fire! the whole bonnet flew off!!

croyden GTR did the same thing, only with his, when he reved and started a burnout, nos thought he was racing, so it put a shot in and had no where to go but up, and lets just saw, the bonnet only just stayed on.

Link to comment
https://www.sau.com.au/forums/topic/60796-nitrous/#findComment-1151980
Share on other sites

Guest
This topic is now closed to further replies.



  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...