Jump to content
SAU Community

Recommended Posts

Hey guyz just a quick question

wats the average fuel consumption for a 1989 r32 gts4 for a full tank

just drivin normal not pushing it constantly

how many km/s should i be gettin out of a tank (AVERAGE)

i need to kno coz this thing is drinkin heaps!

thx

joe

Link to comment
https://www.sau.com.au/forums/topic/63059-fuel-consumption-for-r32/
Share on other sites

i get about 440 to a tank of premium unleaded from mobil or bp.. is your car stock or is it modified heaps? i have 200,000 on the clock and its still running like a dream. have front mount, pod, exhaust, bov ( atmo ) and 500hp fuel pump.

I have a cefiro, so slightly heavier than a normal skyline, but prob about the same as a gts4. And say I go down the coast on a sat nite, drive to work in traffic the rest of the time, Id get about 490-570kms to a tank, then I fill up and only 55L goes in. So work it out. I dont baby the car, but where theres no point in giving it a bit I wont.

So personally I think you lot need better tunes :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...