Jump to content
SAU Community

Recommended Posts

  • Replies 96
  • Created
  • Last Reply

Top Posters In This Topic

Gearbox feels tight, never crunches - old one did sometimes, not very often, the syncros on it were still pretty good... but this one makes a whining noise, already given it back to nissan twice to fix, i think its time i ask for a brand new replacement!

  • 1 month later...

yeah for normal street rubber even in rwd's burnouts are just for show, and the only purpose is to clean crap off the tyres. Unless you are running semi slicks, nittos or slicks a burnout is not needed.

In our GTR R33

we were on the M5 stopped about 8 times to practice launches and have some fun...

My dad was driving so For him its either take off slow or take off on limiter...

He has a good technique which i tend to use now...

8 grand...Ride the clutch till the car starts to move then When your foot is about half way on the clutch Pull it off...(pop it)..This swats the rear end and gets some spin action more screeching sound...

And pulls the car Hard...

Best take off I have ever exerienced...

We got a 0-100km/h

In i think it was 3.7 or 3.9

I have tried other take off's but they tend to bog at anything under 6500rpm...

cheers

ALso....

I know of a friend that had a gtr r32

Mods:

- Full exhaust

- Pod filters

- Clutch had been done (Not sure which one)

he pulled the hoses off the turbo's So he was running max boost

Did several 11.7-11.9sec passes...

But he eventually Killed the motor...

whoever said GT-R's dont run 11's standard... that means you cant drive :wassup:

my mate does consistent 11.7's!!

1.68 60ft

17PSI boost.

New 255 Rubber - street tyre not semi slick.

18" wheels

tein coil overs

standard dump pipe

custom front pipe 3"

hks airpod's with heat sheild

STANDARD ECU . REV LIMITER ETC EVERYTHING FACTORY DEAD STANDARD.

full 3" exhaust 5" hks muffler tip

( i repeat - standard dump pipe(s).)

who said 11's isnt possible?

whoever said GT-R's dont run 11's standard... that means you cant drive :wassup:  

my mate does consistent 11.7's!!

1.68 60ft

17PSI boost.

New 255 Rubber - street tyre not semi slick.

18" wheels

tein coil overs

standard dump pipe

custom front pipe 3"

hks airpod's with heat sheild

STANDARD ECU . REV LIMITER ETC EVERYTHING FACTORY DEAD STANDARD.

full 3" exhaust 5" hks muffler tip

( i repeat - standard dump pipe(s).)

who said 11's isnt possible?

Isn't that boost pushing it a bit hard?

Mums GTR on stock boost with hks dumps and sub-zero exhaust(front pipes back) made over 300awhp. Thing that annoyed me was she was pulling on my 380rwhp gts-t consistently :Oops:

Isn't that boost pushing it a bit hard?

Mums GTR on stock boost with hks dumps and sub-zero exhaust(front pipes back) made over 300awhp. Thing that annoyed me was she was pulling on my 380rwhp gts-t consistently :Oops:

NO!

he has done 15,000klms on 17psi and blown 3 clutches.. so could you imagin how much stress the car has.

he pulled off his turbo's as he is going N1 turbo's now .. the turbo's are like new... shaft play at a minimum.. no chiped wheels etc.

bloody amazing GT-R's!!

I run just over 1bar of boost on my turbos probbaly around 16psi, may spike to 17psi hard to tell... turbos have been going around 40,000ks i believe.

With a dead standard ecu, wouldn't the speed limiter at 180 kick in before the end of the quater mile doing a 11.7? :P

I run just over 1bar of boost on my turbos probbaly around 16psi, may spike to 17psi hard to tell... turbos have been going around 40,000ks i believe.

With a dead standard ecu, wouldn't the speed limiter at 180 kick in before the end of the quater mile doing a 11.7? :P

No, he has a speed cut defender and thats ALL! :P

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
×
×
  • Create New...