Jump to content
SAU Community

15/04/05 - SAu/Mercury Motorsport Meet and Greet BBQ!


Recommended Posts

It's that time again to come and meet and greet the guys at Mercury Motorsport and other members of the club.

A sausage sizzle and cordial/cold water will be provided for free and cans of softdrink will be available at a small cost.

The dyno WILL NOT be run due to the amount of noise complaints that Mercury have been receiving lately. Below is the word from the horses mouth so to speak (will post tomorrow as email is at work).

The Dyno will not be available on BBQ nights. This is due to noise restrictions because of our zoning and we have already had a number of complaints from our neighbours when the dyno has been in use after 7pm. I am more than happy to have people come down early and use the dyno before 7pm (bookings required as usual), but this will be charged at the normal rate (club member discount still applies). It should be stressed that the dyno isn’t really the point of the evenings. It is more a social gathering, where people get to hang out and chat as a club, without fear of police presence, and where myself and my staff are available for a chat, allowing us to give advice, informal estimates and generally just get to know each other better.

Mercury Motosports

Unit 2, 278 Newmarket Rd

Wilston QLD 4051

Phone: 1300 558 650

Starting time of 7pm.

See you there! :burnout:

Also, just a reminder to members and others to me mindful of the other residents within the area. DO NOT leave the Mercury Motorsports premises in a loud and undue manner.

With wados in his falcon and you in your soarer, I think I should bring the commodore ;)

Maybe everyone should bring their "other" cars too, so its everything BUT skylines. That would make me amused, if just for the fact Willis will be bringing the cappa (coolest. car. ever.)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...