Jump to content
SAU Community

Recommended Posts

Think you can get me and my piss weak MX5 to drift mate?

Definately... If you want Fatz will get in the car with you - get you started by body rolling the car. By the end of the day the MX5 will be doing something that resembles a drift. Either way you will have plenty of fun and get plenty of advance car control practice.

can i drift my stock auto? (its a serious question)

Auto really does not stop you doin much.. There are a few drifting autos in competition.

  • Replies 96
  • Created
  • Last Reply

Top Posters In This Topic

My breakage list so far consists of:

Brake Master Cylinder

Calipers

Radiator plastic tank

Exhaust manifold studs

Coils

...and thats 3 trackdays.

ahh you have been unlucky mate.

In over 30 trackdays I did

Rear Diff $500

Engine $2000

which is about $83 in damage per day :spank:

+consumables like brake pads, fluid and oil

Drifting??? Why would ANYONE drift when you could go to a nationally recognised drag racing meet andf compete.

Ghey ar$ed drifters - get over yourselves and come to a REAL motorsport :D

Adrian




  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...