Jump to content
SAU Community

Recommended Posts

  • Replies 412
  • Created
  • Last Reply

Top Posters In This Topic

and is the carpark noticeable when you turn right at those lights, silv?!

noticeable?? lol

you turn right and all you see on you left is a massive car park

it will be empty at night so no speed hump issues etc.

depending on what time you all meet

i might come say hello if you decide to meet there

Well, my dreams have come true, i was supposed to work this weekend, but i have got it off on leave! If i had to work i was gonna chuck a sickie :wassup:

So far so good, im going to go for a cruise through the nasho at around 8pm to make sure the road is open and warm my tires up :D

Ill see you all on waratah street at 9:30pm Sat night! w00t!

How about this one, I know it seems like doubling back or something, but its only 5 mins out of homebush, then back through to kirrawee? big carpark to meet at

Brays Bay Reserve

my advice is don't do brays bay reserve. it is a known pick up point for homosexuals and also for drug deals and of course car clubs. police go through there regularly, not that that should be a problem as I'm sure you will all be driving roadworthy cars in a law abiding fashion, but still the attention is unwanted I'm sure.

my advice is don't do brays bay reserve. it is a known pick up point for homosexuals and also for drug deals and of course car clubs. police go through there regularly, not that that should be a problem as I'm sure you will all be driving roadworthy cars in a law abiding fashion, but still the attention is unwanted I'm sure.

been busted there a couple times have we??

picking up lil boys

lol

Quote: Flora St in kirrawee, there's a fair bit of on street parking there, a very very dead quiet street at night (that part of it is anyway) /Quote...

Probably not a gd idea parkin anywhere on that street, as theres a police station, but maybe all the way further down that street would be ideal..

the police station is on the OTHER side of the street, all the way in sutherland.

Either way, i say we stick to the original plan. 8:30pm meet at homebush, 9:30 meet at kirrawee, 10pm leave for nasho

been busted there a couple times have we??

picking up lil boys

lol

nah, but last time I was at a meet there was two little kids asking for you. they said you had some candy for them? either way that place is best not used for night meets.... unless you're into that.....silver.

dunno mate. thinking about it. not really keen on these big 'runs'. too much opportunity for inexperienced drivers to cause grief to themselves and to me. much prefer a trackday or the like. having said that a nice spirited drive with the legal speed limits (which I'm sure this is) on some nice roads is always fun.

Are you guys sure u want to go through so early? chances are there will be people coming back from the clubs in bundeena and mainbar around that time. some of u 'flamin hooligans' might not want cars coming the otehr way...

Ill be meeting u all at kirrawee

heh This should be good!

looking forward to it!

anyone bringing a dig cam to make a small video or something of the night?

Im bringing digi cam and digi video cam. Ive got 2 passengers so one can take photos and one can take videos! I hope i dont have to much wheight on board! Dont wanna get slowed down in the NASHO! :(

what thomas said!!

guys.. please be careful out there.. there are plenty of straights for overtaking, so wait for them.. none of this overtaking around blind corners as i have seen some idiots do!!!

just remember... its a spirited drive, not a race!!!

meet place is still homebush... seeya there!

:werd:

Especially with the 35 km/h corners. Dont under estimate them! I know 3 people that have lost a car each on this one corner because it has a double apex. All in all we are all in for a fun drive. Moanie, are we gonna stop when we get to stanwell tops? for a regroup then convoy it up the freeway?




  • Similar Content

  • Latest Posts

    • Ok i will get those 310mm. I found one but on a different site. This is the description on those...is it ok? Technical parameters: - Axle: front. - Disc type: ventilated. - Number of holes: 5. - Disc diameter: 310mm. - Total height with center: 54mm. - Thickness (new/min.): 30/28mm. - Designed for brake calipers manufacturer: Sumitomo.
    • You Gregged a whole racetrack!?
    • Look for broken wire or bad connector at the motor. Might not be it, but is worth starting there, as it is easy.
    • Hi everyone, I’m having an issue with my R32 GT-R. Sometimes, when the car goes over a bump or experiences some vibration, the 4WD warning light comes on the dashboard. When I check the code from the control unit in the trunk, it shows Code 19 – ETS Motor. However, everything seems to be working fine — if I turn off the engine and restart the car, the light goes away and everything functions normally. Has anyone experienced this before? Where should I start troubleshooting this issue? Thanks in advance!
    • I'm back from the dyno - again! I went looking for someone who knew LS's and had a roller dyno, to see how it shaped up compared to everything else and confirm the powerband really is peaking where Mr Mamo says it should. TLDR: The dyno result I got this time definitely had the shape of how it feels on the road and finally 'makes sense'. Also we had a bit more time to play with timing on the dyno, it turns out the common practice in LS is to lower the timing around peak torque and restore it to max after. So given a car was on the dyno and mostly dialled in already, it was time for tweaking. Luis at APS is definitely knowledgable when it came to this and had overlays ready to go and was happy to share. If you map out your cylinder airmass you start seeing graphs that look a LOT like the engine's torque curve. The good thing also is if you map out your timing curve when you're avoiding knock... this curve very much looks like the inverse of the airmass curve. The result? Well it's another 10.7kw/14hp kw from where I drove it in at. Pretty much everywhere, too. As to how much this car actually makes in Hub Dyno numbers, American Dyno numbers, or Mainline dyno numbers, I say I don't know and it's gone up ~25kw since I started tinkering lol. It IS interesting how the shorter ratio gears I have aren't scaled right on this dyno - 6840RPM is 199KMH, not 175KMH. I have also seen other printouts here with cars with less mods at much higher "kmh" for their RPM due Commodores having 3.45's or longer (!) rear diff ratios maxing out 4th gear which is the 1:1 gear on the T56. Does this matter? No, not really. The real answer is go to the strip and see what it traps, but: I guess I should have gone last Sunday...
×
×
  • Create New...