Jump to content
SAU Community

Recommended Posts

I have a made who lives in bridgeman downs.. When they were developing the area we did a 5000rpm clutch dump u-turn in a cul-de-sac, NO houses around at all, left the faintest of lines.

Copper who lived a few hundred meters away got his rego

got the accident investiagtion squad out

took photographic evidence of the faint skid marks

took rubber samples

had them matched to his car

took him to court

driving without due care and attention/excess noise

There must be some 'tard out that way who dislikes cars

most cops by the time they get to traffic duty are fairly senior.. senior counstable or more likely seargent.. Unfortunately you are right there Dave, in that they do have a bit of training in that area. Although it might be about 2-3 years since they did the course, it's possible their memory is hazy.  

ADR's are nothing to be scared of, most cars should pass if the obvious things are legal.

p.s.. deanx0r: unfortunately that would mean your nice bling 19" rims are 2" too large :P

From my understanding, all mods are illegal. That simple. But if you read differnet laws you can do a few things, but the way I read it they get over powered by the 'all mods are illegal' one.

From my understanding, all mods are illegal. That simple. But if you read differnet laws you can do a few things, but the way I read it they get over powered by the 'all mods are illegal' one.

Why does QLD Transport produce a brochure stated "guides to modifications" and mention a few key things then stating what you are, and are not allowed to do to your car? That should be the bible that should over rule any cop's idea of what is, or is not legal -- as they are the ones registering your vehicle, not the police. AFIAK it is them who are deciding which cars ultimately are to be registered and legal on our roads, not the cops. The cops job (as they should see it at least) is to question whether they are, and send them to be inspected through the proper channels. At very worse, your car is complied when it comes into the country, therefore it is complied to meet all applicable ADR's of that time. Period, cops should not even be able to question a car that was as complied with the plate recently.. although sure, they'd argue you could have changed something the day after.

What you do to it afterwards is your own business, but if you installed all original ADR compliant gear for that vehicle (sold in australia, with stickers stating compliance to ADRs) - you would be all legal. Sure, not many people do go for local gear, but it's all possible. Which also gives me a good idea...

Its all a crock of shit anyhow, as studies have time and time again said that modifications can be attributed to less than 5% of accidents.

By that logic, fitting aftermarket brake pads, or tyres would also be illegal.

my dad was in a big conferance and with senior police and rta people, and asked the police how they would go in court if they defected some one with out the proper qualifications to make the right judgement, the senior sargent had nothing to say and dad said " you wouldnt stand a chance would you, the sargent replyed, " no not really" and that is strait from a senior copper admitting it

'

...

By that logic, fitting aftermarket brake pads, or tyres would also be illegal.

Going by my understanding yes. But then if its plated, they are legal. But not legal. Its a stupid system, and it needs a nation wide overhaul so we are all useing the same laws.

And yeah, I have nothing to worry about with my 15yo rule complied car :P Other than tyres.

Hrm.. so a cop that is off duty can still book you? WTF ?

Read it Alex. He was hooning about on the Sunday. Cop took the plates then. Then back on work Monday, must have been a slow day, no stabbings or anything, so he went looking for old mate to book him for interupting his sunday arvo nap.

once the 'officer' gave his evidence, and provided, he told the truth and said that he took your rego on his day off, this would get thrown out of court so quick there'd be no use sitting down to start with.

well so my laywer friend tells me anyway, but then again that's just his view.

And as silver'sr33 said above, the only thing cops can book you on with reguard to the 'hardware' of your car is your tyres, i'm pretty sure they need transport officers with them to issue any ticket's. <---- could be wrong, just what i've been told.

in any case do something about it, i wanna see the little man win against the system!

Any large dept of people (police/k-mart)

Doesnt matter which store/goverment dept, but there is always a case of getting nice people and rude people. If you dont make complaints you cant get rid of the rude people.

He mus have been pretty keen to issue a fellow neighbour a ticket.....!

I used to live at Bridgeman Downs and a senior of Police (back in 97) lived over the road. One night a friend and i were having an arguement (over a chick of course). After nothing was resolved he jumped into his car and boy o boy did he light em up.

He then did a u-turn over our front lawn and ripped it up. Then the street was not wide enough so he ripped up the lawn on the opisite side also.... BIG MISTAKE....

Lost his licience for 3 years. Not good mates anymore and i liked my neighbours.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Power is fed to the ECU when the ignition switch is switched to IGN, at terminal 58. That same wire also connects to the ECCS relay to provide both the coil power and the contact side. When the ECU sees power at 58 it switches 16 to earth, which pulls the ECCS relay on, which feeds main power into the ECU and also to a bunch of other things. None of this is directly involved in the fuel pump - it just has to happen first. The ECU will pull terminal 18 to earth when it wants the fuel pump to run. This allows the fuel pump relay to pull in, which switches power on into the rest of the fuel pump control equipment. The fuel pump control regulator is controlled from terminal 104 on the ECU and is switched high or low depending on whether the ECU thinks the pump needs to run high or low. (I don't know which way around that is, and it really doesn't matter right now). The fuel pump control reg is really just a resistor that controls how the power through the pump goes to earth. Either straight to earth, or via the resistor. This part doesn't matter much to us today. The power to the fuel pump relay comes from one of the switched wires from the IGN switch and fusebox that is not shown off to the left of this page. That power runs the fuel pump relay coil and a number of other engine peripherals. Those peripherals don't really matter. All that matters is that there should be power available at the relay when the key is in the right position. At least - I think it's switched. If it's not switched, then power will be there all the time. Either way, if you don't have power there when you need it (ie, key on) then it won't work. The input-output switching side of the relay gains its power from a line similar (but not the same as) the one that feeds the ECU. SO I presume that is switched. Again, if there is not power there when you need it, then you have to look upstream. And... the upshot of all that? There is no "ground" at the fuel pump relay. Where you say: and say that pin 1 Black/Pink is ground, that is not true. The ECU trigger is AF73, is black/pink, and is the "ground". When the ECU says it is. The Blue/White wire is the "constant" 12V to power the relay's coil. And when I say "constant", I mean it may well only be on when the key is on. As I said above. So, when the ECU says not to be running the pump (which is any time after about 3s of switching on, with no crank signal or engine speed yet), then you should see 12V at both 1 and 2. Because the 12V will be all the way up to the ECU terminal 18, waiting to be switched to ground. When the ECU switches the fuel pump on, then AF73 should go to ~0V, having been switched to ground and the voltage drop now occurring over the relay coil. 3 & 5 are easy. 5 is the other "constant" 12V, that may or may not be constant but will very much want to be there when the key is on. Same as above. 3 goes to the pump. There should never be 12V visible at 3 unless the relay is pulled in. As to where the immobiliser might have been spliced into all this.... It will either have to be on wire AF70 or AF71, whichever is most accessible near the alarm. Given that all those wires run from the engine bay fusebox or the ECU, via the driver's area to the rear of the car, it could really be either. AF70 will be the same colour from the appropriate fuse all the way to the pump. If it has been cut and is dangling, you should be able to see that  in that area somewhere. Same with AF71.   You really should be able to force the pump to run. Just jump 12V onto AF72 and it should go. That will prove that the pump itself is willing to go along with you when you sort out the upstream. You really should be able to force the fuel pump relay on. Just short AF73 to earth when the key is on. If the pump runs, then the relay is fine, and all the power up to both inputs on the relay is fine. If it doesn't run (and given that you checked the relay itself actually works) then one or both of AF70 and AF71 are not bringing power to the game.
    • @PranK can you elaborate further on the Colorlock Dye? The website has a lot of options. I'm sure you've done all the research. I have old genuine leather seats that I have bought various refurbing creams and such, but never a dye. Any info on how long it lasts? Does it wash out? Is it a hassle? What product do I actually need? Am I just buying this kit and following the steps the page advises or something else? https://www.colourlockaustralia.com.au/colourlock-leather-repair-kit-dye.html
    • These going to fit over the big brakes? I'd be reeeeeeeeaaaall hesitant to believe so.
    • The leather work properly stunned me. Again, I am thankful that the leather was in such good condition. I'm not sure what the indent is at the top of the passenger seat. Like somebody was sitting in it with a golf ball between their shoulders. The wheels are more grey than silver now and missing a lot of gloss.  Here's one with nice silver wheels.
    • It's amazing how well the works on the leather seats. Looks mint. Looking forward to see how you go with the wheels. They do suit the car! Gutter rash is easy to fix, but I'm curious about getting the colour done.
×
×
  • Create New...