Jump to content
SAU Community

Recommended Posts

Hi peoples,

I am trying to help my old man diagnose a problem on his R33 RB25DET. It seems to be running lean, an a/f problem that has possibly increased over time and now shows its head through a loss of power above say 4800rpm to the redline. Below this rpm it seems fine, its just feels like its being held back a bit up there and sometimes worse than other times. The car is completely driveable no stalls or serious spluttering, just not pulling hard to the redline like it should and possibly unburnt fuel going through

timing or mapping??

sensors - afm, O2, crank angle

coils, spark plugs - coils checked out fine apparently

The car has had steady state modifications for years which include only 3" full exhaust and HKS pod, stock boost 7-9 psi max I guess, and I noticed speed limiter removed otherwise stock ecu I assume.

Been treated and serviced well, I have a readout from the diagnostics if anyone could have a sqiz, I guess the afm/O2 sensor readings are about what would be expected at those rpm?? otherwise those sensors could be the problem but I guess they should have noticed or checked those external sensors were ok?

computer codes were all clear too

RB25DET diagnostic readout

I guess the bottom line may be get her on a dyno, but I would appreciate some ideas or experiences from other RB25ers!!

cheers

Link to comment
https://www.sau.com.au/forums/topic/74816-rb25det-not-pulling-to-the-redline/
Share on other sites

wow cool diag, where did that diag printout come from? a nissan dealer?

02 sensor wont cause the problem your experiecing. do you get any smoke or wierd noises, any whining or spluttering on boost etc?

yeh he took it to a Nissan dealer, there is also some pinging around but no obvious smoke and not really a huge amount of jerkiness - it seems to come on boost fine, pull up to around 4700-4800 rpm then just not take advantage of the boost at those high rpms cause of timing or mapping im thinking, but this obviously makes a fair few assumptions.....

I could swear I can hear some fuel going through the muffler when its doing it badly

The most common R33 misfire problem is due to cracked coils.

This usually causes the car to run rich though, not lean.

Anyhow give this solution a try, it will only cost you $5 or $10

http://www.skylinesaustralia.com/forums/sh...ead.php?t=51046

Also gap your spark plugs down to 0.8 mm if you haven't already.

The most common R33 misfire problem is due to cracked coils.

This usually causes the car to run rich though, not lean.

Anyhow give this solution a try, it will only cost you $5 or $10

http://www.skylinesaustralia.com/forums/sh...ead.php?t=51046

Also gap your spark plugs down to 0.8 mm if you haven't already.

cheers for ideas guys,

my first idea was coils also but apparently they checked ok and they reckon the problem is elsewhere, and it is pinging etc

Don't mean to drag the issue of the coils on, but when mine were *REALLY BAD* (all 6 crackd, and 1 had a missing spring, and the contact surface oxidized - went completely green), the car would not go past 3,500 - 4000 rpm at all. Not even if you pushed it.

They connected it up to nissan consult, and no error codes.

On visual inspecion the cracks could not be seen on this particular set of coils.

I swapped them with a set that had huge cracks, and were covered in Araldite. I still have that set of coils in there now.

How did you test/check coils? (Just to be sure)

  • 2 weeks later...

haha....ok... ive decided nissan dealer mechanics are like monkeys with spanners :chairshot , I guess they just do regular services on normal nissans

took it back to Powerplay where its usually serviced, threw a set of splitfire coils on and a r34 gtr fuel pump and its pulling like it used to :)

thanks for the help and persistence with the coils thing, oh and also new spark plugs for good measure

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • Thank you so much for the help
×
×
  • Create New...