Jump to content
SAU Community

Recommended Posts

Hey guys,

My cousin got a GTST R32 recently from Japan, with a buggered engine. Recently, he bought a second hand engine and put it in the car.

Car is a 1990 model R32 GTST (AWD) Manual.

The problem:

If you drive the car normally, it drives fine. Very smooth, turbo spools well, car accelerates adequately. However, when you accelearte hard, it hesitates, backfires at high revs.

ANy1 can help?

Link to comment
https://www.sau.com.au/forums/topic/76271-gtst-playing-up-help/
Share on other sites

it will most probably the coils or the spark plugs or a combination

first buy some new plugs and gap them to 0.8

if that does not improve the situation try swapping the coils for known good ones.

Thanx i've forwarded the information.

Also, at high revs it literally sounds like something is 'sparking' kinda like fireworks, followed by smoke coming out the exhaust.

IF YOu hammer it in first, it goes alright, just a bit of backfire, but in second, its bad, backfires and hesitates, doesn't go anywhere.

Thanx i've forwarded the information.  

Also, at high revs it literally sounds like something is 'sparking' kinda like fireworks, followed by smoke coming out the exhaust.  

IF YOu hammer it in first, it goes alright, just a bit of backfire, but in second, its bad, backfires and hesitates, doesn't go anywhere.

yeah well that sounds like it could be what i explained as the misfire is worse with more load, so the higher the gear the earlier the misfire.

maybe but i doubt it, when the coils are stuffed it makes a noise like that as well, it is unburnt fuel ingiting on the way out, its high frequency popping, which is probably what he is explaining.

Yep its high frequency popping.

Also, i forgot to mention the car tends to stall in neutral or at low revs. Once the car is stalled, its hard to start again....i.e it doesn't start first time....takes a few attempts before it starts.

well due to the bad misfiring the plugs could be badly fouled, resulting in an unstable idle and making it hard to start.

first of all if were your friend i would pull out the plugs and have a look.

Thanx man for the help.

I told him to sus out the plugs.

How much would a new set of plugs cost?

u can use coppers if you change them regularly (5-10000kms) or else platinums/iridiums which will last a bit longer

coppers will cost about $18-25 a set, iridiums/platiunums will be about 90-120 a set (might not last long either if the car is running how it is now, so i would recommend coppers for now at least!)

OK another development.....we both have exams right now so haven't had time to check anything in detail....but now the car is very difficult to start, and very difficult to keep idle. Quite often it stalls, 90% of the time when started it just coughz, doesnt rev well, heaps of black smoke comes out the back!!! worried....

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
    • Oh, and as for everyone with their fuel economy changes, I switch between E10 and 98 in the company car. Even do when I had personal cars that could run on E10. You know what changed my fuel economy in any noticeable way? How I drove, and where I drove. Otherwise, say on full tanks of just back and forth from work only (So same trips, same sort of traffic), couldn't notice a difference that I can correlate to the type of fuel in use. In the current vehicle, that's over 42L of USABLE fuel. While 98 is all "more energy dense", it also has higher knock resistance as it takes more energy to get it to ignite too. The longer hydrocarbons, typically more tightly bound. So running the same ignition map, can also produce less power, if there isn't enough time to get it all burnt through properly, as yep, the flame propagation speed is different from lower octane fuel to higher (Higher has a lower flame propagation, due to the more tightly bound and harder to self ignite funs. This is also typically where, a vehicle that is designed purely to run on 91 (Whether it be E10 or normal 91) usually sees absolutely no real world difference in fuel economy for the normal man, woman, or dog.
    • We've got some servos around me that have 91 with E10, 91 (no E10), 95, and 98. At those stations the change from 91 E10 to 91, is typically around 8c/L.   But lets not get started on the price of fuel in Oz. It's ridiculous. All the service stations around me, bar one, the price of fuel has been over the $2 mark per litre for the cheapest, 98 being around $2.45. That one service station is a CostCo, fuel from it comes from the same refineries, and makes no pitstops, it runs great, including the 98. In fact, I've had no issues on CostCo fuel, but plenty of issues at other stations!. The CostCo fuel, was $1.65 roughly this week for 94 with E10. $1.88 for 98. Servos directly across from it, $2.10 for 91 E10, and $2.48 for 98. The part I had to laugh at? If I drive multiple HOURS away from Brisbane, say out near Nanango, or Kingaroy, or even out to Goondiwindi, the price of their fuel, is the same as what it is at the CostCo... Oh, and that BP servo at Goondiwindi is HUGE and goes through epic turnover of fuel, so it's not sitting there for weeks going to shit. And what blows me away, my mate is one of the people who drives the Fuel Tanker all around QLD, delivering to all those places. At the same company his previous role was doing the "local haul" deliveries... Same truck, same driver, same pickup point it all comes from. So you tell me, how the hell it is 60c/L CHEAPER for fuel, when nearly all else is equal, except they require a B-Double to drive half a day out of Brisbane, and half a day back, every second day, compared to the delivery that can be under 30 minutes drive from the fuel pickup point... Not to mention, go five blocks down the road, and Ampol to Ampol will vary 30c/L... And I've had this conversation with my mate... The way it's priced, is just typical, pure and utter rubbish... He also does runs from Brisbane, to all over QLD, down to Newcastle, Sydney, Nowra, Melbourne, Geelong, and even out to parts of the NT depending on the companies needs. His main stuff is all the longer distance away from home for a few days at a time, then when he's back, he loves to just pickup extra shifts wherever he can in whichever truck, hence all the weird different places.   Oh, as for getting E10 into all the fuels in Australia... It was very quickly highlighted, that we don't have enough biomass available to use to make E10 sustainably like they require, and it would dramatically cut into our, and the worlds food chain supply...   I vote we all just start running on liquid methane gas... Plenty of that just getting tapped off at tips from underground decay... (Note, this is pure just stupid commenting. I could very easily highlight the reasons its not a good idea especially on scale...)
    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
×
×
  • Create New...