Jump to content
SAU Community

Recommended Posts

hey people i need some advice,

i have a rb20det 5 spd in my S13 silvia....

tonight all of a sudden it started rumbling and it sounded exactly like a WRX boxer engine. it was making normal boost levels but the power felt lower and it was very lumpy!!!! i pulled over and had a look under the bonnet, when i gave the throttle a little twist, i could hear a sound like a hiss. i couldn't destinguish if it was an air leak or if it was like a squirting sound. (if you understand me?) but the sound was around the top of the engine where the intake pipe meets the throttle body. is this a common problem some people have heard? or will it be something to go see a doctor about???

after i stopped after and turned off the engine for 30 mins it was fine again. then it happened for about 5 minutes while driving home. what is thisssssss?????

any help would be appreciated.

Link to comment
https://www.sau.com.au/forums/topic/77208-rb20det-problem-wrx-sound/
Share on other sites

Dead coil pack dude! Guarentee it. Take off the plug cover and unplug each one individually. The engine will run even rougher on each one. When you unplug the one that makes no difference you've found the stuffed one :D

Mine did this when I imported it and as soon as it got warm the dodgy one would fail.

good luck.

I had the same problem but it was a spark plug,the ceramic bit above the gap cracked and slid down to cover the spark gap.Everynow and then it would back to normal,must of been the comp pushing it back up etc.

So yer as baselinez said coil pack coz it's not sparking.

Also spray carby clean around the inlet manifold(where the top/bottom meets)join and see if the idle changes.Could be gasket or maybe just tighting of the bolts.

I have had this problem many times and had many reasons for it.

As mentioned it could be a faulty plug or a faulty ignition coil or module. It can also be caused by a leak in the inlet tract.

As you heard a hissing sound around the throttle area I would be starting there first and looking closely at the rubber joiner for a split.

And while you have the crossover pipe off may as well throw in some new plugs.

Its gotta be ignition.

Mine comes and goes just like that on my RB26. Seriously just goes into Rexy mode, then 5mins later, goes to GTR mode. (GTR is better by the way, hehe).

It has to be ignition, because if it was a cracked seal or something it would be more constant, I think mine might even be the plug going into the module, hope its not a coil pack.

will a dud coil pack come and go though? cause today the problem seemed not existent. but i bet it'll go on the weekend again. also just noticed my clutch is starting to get very slippery, so thats more money i have to spend. is the RB sound really worth it in the end??? i'm thinking maybe an SR would have been the better option :D

just like almost the majority of contributors on this thread, i say that it is you coils. get them replaced.

(quote:'m thinking maybe an SR would have been the better option ) believe me, the RB is way better!

Dude, its basically the only problem the RBs have and its just due to age. Yes with my car the problem came and went until it stayed stuffed for good.

Do the test and it will prove if its them or not.

You can't blame a slipping clutch on the motor type :D Its just one of those things. Stick with it, the RB shits on the SR. One dud coil is the only problem i've had on mine in 6 months since I imported it. Fix it and you'll be fine! Keep us posted!

lol that was what i was like too, i was like: "hey cool i sound like a modded WRX!" then i started driving like miss daisy and worrying about it hahahah but i enjoyed the sound but not the rumble through the car etc.

i will try to suss out the coil packs on the weekend, and get back to you's!

Anyone?

Can you tell us how to test each coil?

Because if its going to be a matter of trialing each coil being swapped over, it could take 3 months, as its inconsistant whether it works or not. So I'll swap one, then wait a week, then swap the next one, wait another week or two and so on.

There must be some way to test.

Like he said, just unplug them one by one, if the one you unplug is GOOD the car will sound even WORSE, so plug it back in and move on to another until you get to one that when unplugged makes no difference, that's the cylinder that's down.

But don't just assume it's the coil, pull the spark plug out and check it (is if fouled? clean it and see if things improve), swap a pack around and see if the dropped cylinder follows the coil, if not to loom could be damaged, etc.

If it's a dud coilpack buy a new one, or if you intend to run high-boost in the future maybe think about a set of SplitFires (~$650).

I say again:

Because if its going to be a matter of trialing each coil being swapped over, it could take 3 months, as its inconsistant whether it works or not. So I'll swap one, then wait a week, then swap the next one, wait another week or two and so on.

This is relevant because the guy the started the thread and myself are NOT having the problem all the time, but would like to fix it before it comes an ALL THE TIME thing.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Here's the chart for fuel pressure vs. current draw, assuming your base fuel pressure is 3 bar and you run like 0.5bar boost on WOT, you should only momentarily hit 9amps here and there. (Ignore my prev post, I cannot read a chart these days it seems)
    • Those comp test results are not hideous. Whether they are accurate or not (ie, when that comp tester says 140 psi, is the real pressure120, 140 or 160?) is unknown to us. The state of the battery used to crank it over is unknown, etc etc. Many people around here would say that the absolute values and the spread are perfectly fine to just add boost and keep going. I personally would be happier with a narrower spread than that, but even the diff between 125 and 145 is not terrible. That one cylinder at 125 though, has probably copped some damage relative to the others. You should inspect the valves seeing as you've got it open. Do you know how to measure installed ring gaps? That, and an inspection of the rings themselves, is how you will determine whether they need to be replaced. If you're not good to do these things, take the block and the pistons and rings to a shop that is, and ask them for the go/no-go on them. Do the bores need a hone at all? If so, you might well be justified in getting some different pistons in order to get away from the ring supply problem. Whether you're happy to spend a lot more money right now, on more gear, rather than less money, but an amount that looks stupid given that you will only get a handful of rings in exchange for that money, is for you to decide.
    • also possibly backed up to my filler and shat down it! 🤣
    • Ok so i would love some advice here please, i purchased an R33 a few months back and its had a few mods done to the engine, its an RB25det running a Master ECU, 1200cc injectors, bigger turbo, oil cooler, oil filter relocation kit, Spool H-beam rods, acl/ross pistons. When i removed the motor from the vehicle (as its getting a respray) i thought i would compression test it and these are the following results. Cylinder 1-145psi, Cylinder 2-143psi, Cylinder 3-125psi, Cylinder 4-145psi, Cylinder 5-140psi, Cylinder 6-135psi this test was done with the motor on the ground and powering up the starter motor. I dropped the sump and found broken oil squirters on cylinder 3,5 and 6. I was told my rings are probably worn so i stripped the motor completely to get a new set of rings for it. The trouble is no one has these rings anywhere and they have to be custom made by Ross over in the states and will cost about $600+$200 delivery. My question is how can i tell if my rings are at fault and if they are still ok and is this price ok for a set of rings?
    • What sold me on Trailer Park Boys is this scene: Great stuff, just stay clear from the new Netflix production.
×
×
  • Create New...