Jump to content
SAU Community

Recommended Posts

I'd like a R33 floor brace, the one which runs just behind the front seats and bolts to the 2 front seat belt mounts. They make them for R32 and S13 but haven't seen for R33.

If we can get sufficient interest I will organise for them to be fabricated. Probably need 10+ people and I won't be getting one unless it is under $200 to give you an idea of pricing.

Melbourne only unless you are willing to organise your own freight.

Link to comment
https://www.sau.com.au/forums/topic/77701-eoi-r33-floor-brace-group-buy/
Share on other sites

was thinking the same thing myself??? :confused:

Ditto....

I have heard there things do nothing but extra weight in the car and weight reduction in your wallet.

Greg

I have heard they they make a difference. I'm willing to give it a shot for under $200.

Does anyone actually have one fitted?

I suppose for under $200 wouldn't be bad. Could save your life in a side on impact...

Greg

hey guys, sounds like an interesting test, group buy. i have seen one fitted to bnr32 but not r33. i have rear and engine sway bars and they do a world of good in terms of handling. i'd hate to magine handling with them out, will be keen to see this progress.

i have had friends be in my car and comment on the handling from the stock setup and how well it goes sideways. for those doubting the sway bar/strut bar effectiveness i welcome u to come for a quick fang in my car, and ill demonstrate :devfu:

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Ok I get you. But isn’t the butterfly intake a headache with the +T?  see this is my plan so far but please advise me into the right direction.  Nistune Ecu, 1000cc Bosch injectors, TD05 or TD06 Kinugawa turbo using stock rb25det exhuast manifold, walbro fuel pump unsure of model I think it’s 450/460, spitfire coils and sparks to suit and a R35 MAF sensor and boost sensor.    I was thinking maybe do a cheap eBay plenum $400-500 or try find a stock det neo intake. I think I’d port match it so it’s getting the full capacity but open to advice please.  Thanks 
    • The issue now is the 'fuel cut' while driving, and when it happend, it does not stall. This, I did not test the fuel pressure while driving as I cannot with a fuel pressure gauge. I do have Nistune logs, yes. I have also replaced the MAF Sensor.   Also related to the FPG Fuel Hanger – I just realized that I need a Deutsch Crimp Tool to crimp some cables for the FPG Fuel Hanger. Need to purchase additional cables as the kit only included 2, which are for the float. FPG has not responded to my emails so far since purchasing. I thought about taking it to someone and having it done professionally, but I am reluctant since everyone I took it to messed up in some way.  
    • There's a good German place in Brisbane if youre up for the drive 😛
    • The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
×
×
  • Create New...