Jump to content
SAU Community

Recommended Posts

  • Replies 95
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Guest DIRTgarage
hahaha where did I say I'd enter

did not say enter.....interested was the word i used??

"Sorry about that, it honestly didn't cross my mind I'm not really into dyno comps"

BU5TER

Edited by DIRTgarage

Yeah read a bit earlier and I said I can kill 2 birds with one stone as I know one of the owners of the workshop and he's asked me a couple of times to call in, so while fellow SAUers are there I can call in and say hi to them and Matt at the same time making it more of a social call then a dyno comp for me, though if you really want to push the point another good reson I wasn't really interested was I HATE CABIN AND THERE CRAP DYNO COMPS AND CAR SHOWS AND REFUSE TO SUPPORT THEM SINCE THEY POO POOD SPORTS COMPACT I aslo hate 1/2 the cars at there shows and what they represent ;) but if it does it for you I'm happy for you

Guest DIRTgarage
well remember I'm old with 3 kids so loud noises and bright lights hurt my eyes :)

nerve touched..........just sh1t stirrin' ya mate....dont take it too hard.

agree the shows are a wank, but the opportunity for Stace to take the car down and compete in front of her home crowed(sp) was great, and ill always support anything she does.....im sure if your wife was there competing you would do the same.

im old with child too, bright lights and loud sh1t music annoy me also!

was only there for the dyno comp....the rest of the weekend the car was there on its own.

[cabin] rethink your position on racing........not everyone gets off on glorified carparks




  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...