Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

damn u paul

i said to stop whoring untill i got home!

i only got home late

rather eventful trip home

got pulled over by cops for routine traffic check

said i have to replace back tyres they are 2 bald and if they see me again they gonna pull me over and check my tyres to see if i replaced them otherwise it's a yellow for me! surprisingly he didn't say anything bout my a-pillar boost guage even though he flashed his light for like 5 yrs on it! and the funny thing is he tried telling me that i had tint on my headlights and that my rear spoiler was too high :(

yeah my dad was at the lights with a copper behind him and he must of breathed the wrong way or something because they pulled him over and told him he needed new tyres on his brand spanka off the factory floor clubby! My dad told him this - which is a bad idea - tell a copper they are wrong - but it was so stupid they were determined to pick something wrong in this car.

ahhh tim to whore

after another day at work!

another week and my front bar goes on!

i can't wait!

i will be without a car for like a whole week though i fink!

looks like i will be renting a car! haha good ole ascents lol!

adrian :(

Guest
This topic is now closed to further replies.



  • Latest Posts

    • That looks good, but I think you're going to need much beefier side skirts now.
    • They are daft and there's a reason it never caught on. Steering feel? We don't need no stinking steering feel!
    • I gotta pull you up on this. It's driving me crazy. A shutter is something that closes, like over a window or in a cmera. The word you want is shudder. That LSD is clearly f**ked. Take it to a diff shop and get it disassembled and examined by an expert. YOu might have plates welded together or something equally crazy.
    • Define "starting to fail". Wy not just rebuild them?
    • Check the Nistune doco. There are a few assumptions being made here that might not be valid. I will list the things that occur to me: Base map. Base map for what? Base map for Z32? Then the cranking pulse width is probably wrong for an RB25. The extra 500cc of capacity might well be enough to prevent it from catching. Base map for RB25? I don't think you can load one of those into a Z32. You have to just make the settings correct for an RB25 in the Z32 base map. That is either K or the TIM to get the pulsewidth right. Loom. You bought a loom for an RB. And you plugged it into a Z32 ECU. Did you make sure that any iwre differences were swapped. From memory, there's at least a couple. And as per the others, I would suggest making sure that the fuel pressure is correct while cranking and that the injectors are actually flowing as expected. They really must come out and go on the bench, unless you do find that you have messed up as per above points. I would also suggest watching in Nistune to make sure that everything is reading correctly. That the correct binary flags are raised at the right time (like the crank signal), that there's no stupid values in K or TIM. That you have not got mismatched firmware for the ECU and/or a wrong image loaded.
×
×
  • Create New...