Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

My clutch does occasionally make a funny noise, kinda like a shutter, but it doenst seem to worrying....

My car is getting the AVC-R tuned and dyno'd.... apparently it put out some fairly good results on the Genie Dyno..... I might take it to Steve as well to see how the readings compare if I can find the money at some stage...

Hmmm yes but I need to get from Perth to Myaree.... Hmmm... Time to ring around everyone I know :D

actually no i cant because i wiped the email i copied it from and i cant be bothered typing it all again basic story is i panicked cos there was a plastic burning smell coming from my car drove into a servo made a big fuss then realised it was a plastic bag hanging from my exhaust!

Hehe ... Niz is funny....

Paul I will do my best to pop in..... I am ringing around my friends to see if I can get a lift there today... I should get a copy of the dyno reading so it could be a good way of testing the relationship between the two dynos and readings....

How much for a power run though??? Does steve mind???

I am already putting this tuning on my credit card.... Damn getting paid monthly....

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Where is the warning "That this thread is super old"   I just went into a 5 year old thread, went to do a reply, and couldn't see anywhere obvious a warning of it being super old
    • Duncan is correct. Pitwork (and Toyota's own cheap brand "Drive Joy") were primarily created as brands to sell other manufacturers car parts. It would be weird if Nissan sold parts for Toyota vehicles with a Nissan logo on it, so they created Pitwork to sell parts for other brans Toyota, Honda etc. They are not the same as Nissan genuine parts, although they *do* meet Nissan's standards for replacement parts. They aren't supposed to be a substitute for genuine parts, but a cheaper alternative that is better than Ebay fake parts from you-know-where.
    • Thanks GTSBoy, much easier to work with it now it's free!  
    • I _think_ that one has a christmas tree or some other retainer spike into a hole in that panel under it. Come in under it with thin scredrivers and just pry it gently up. If you rip the ears off the retainer pin....so what? Just stick it back down after with a bit of race tape and carry on with life.
    • Here's a pic of the damn thing
×
×
  • Create New...