Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

its not charm - i looked shocking that day i did that had a huge fight with the boy being a prick so i told him he could shove it and drove home to mummy in tears and was pissed off that led to roadrage cos i thought the cop was trying to drag and fark with me. its just all about being honest about what you did and lying and saying it wont happen again and yes usually a short skirt helps too :P had one copper i didnt know whether he was trying to write me a ticket or pick me up he was that dodgy!

haha if you show me this skirt paul - i may have a pair of heels to match u can borrow - might as well go the whole way haha legs may need a bit of a wax tho - unless your going for the italian look :P hehe

i know - then they wouldve picked on some poor other soul that car just aint that quick! Ive gone past coppers before they put on their lights then took themoff again cos they decided they would rather sit on the side of the road and eat donuts instead i guess - talk about bloody lazy.

Guest
This topic is now closed to further replies.



  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...