Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Gees , finally catch up and everyone shoots thru.

Ohh well , will be back on later and yes Paul , I could prolly put the Race R in the salon thingy but I will be driving it , not you or shuto boy. Hehehe.

Hopefully will have the AP 6 spots on by then and will definitely have the Autronics and 581's on .

Btw , will be patchy with posting over the next week cos am doing funeral arrangements.

Niz , is your car any better or worse or the same ?

Cheers

Ken

ken car is better - there is still a problem but its not shuddering as much in idle now - just seems slightly more of a slug thats all - but its cool will tide me over til next service which is due middle of this month anyway. :P thanks heaps for ur help

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...