Jump to content
SAU Community

Recommended Posts

Originally posted by SHUTO-BOY

psiker: do u know why the n/a mitsubishi engines sound loud? almost sound like vtech's,i never figured out why

(it was loud even before i set the rpm redzone to 8000rpm)

i dont know hey. my mates na lancer has a pod filter and it is *** off loud. i can hear him coming a few streets away. for some reason when u put a pod on them they scream like banshees :) cool but very ricey :)

Psiker

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by Psiker

for some reason when u put a pod on them they scream like banshees

that is SOOOO obvious..

its the sound of the suction..

sometimes the pod and the exhaust overlap.. and creates a cool sound..

Originally posted by darK

that is SOOOO obvious..

its the sound of the suction..

sometimes the pod and the exhaust overlap.. and creates a cool sound..

i understand that, but even the pod on my bros 180 isnt that loud. u can hear it suck like a street walker but it doesnt scream like its just been stabbed 9 times in the back

Psiker

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Not sure the US can import anything other than the C34 Stagea's, but if you can and you need to to tow, DO NOT under any circumstances get an M35 Stagea. If it is just as a family car and your country/state allows it, absolutely and definitely get an M35 (3.5L if possible as it is effectively a 350Z) over a C34.
    • Punch your VIN (nm35-xxxxxx) into Amayama.com You can see everything there quite easily.
    • Thanks for that, I'll check it all out. I can always do the brakes last anyway if its a problem.  The 16's are super cool, if they do fit I'll cruise around with them for a bit.  
    • Well, that's kinda the point. The calipers might interfere with the inside of the barrels 16" rims are only about 14" inside the barrels, which is ~350mm, and 334mm rotors only leave about 8mm outboard for the caliper before you get to 350, And.... that;s not gunna be enough. If the rims have a larger ID than that, you might sneak it in. I'd be putting a measuring stick inside the wheel and eyeballing the extra required for the caliper outboard of the rotor before committing to bolting it all on.
×
×
  • Create New...