Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by GTS-t VSPEC

I'm not that short, not compared to you Bayley:p

See'ya:burnout:

Oh well, it must have been me blocking the exhaust then, didn't I tell you I love climbing in car exhausts!

I am allowed to be short Paul, I am a female, you are supposed to be big and strong and protect us girls! I think Nizzy would look after you more than you can look after her!! (hehe!)

sneeza,

oh...

I vote for steak btw. Cook it in a pan with olive oil, white wine vinegar (or wine preferably semillion), crushed garlic,taragon, a tablespoon of whole grain mustard, thinly sliced feild mushrooms and some fresh sliced chilli (if you like the spicy stuff).

You said it Paul, not me!

Jeff used to work across the road from Murdoch at Rocko Boating Centre and we used to see your Skyline and he never used to shut up about it. Dunno why with that Commodore spoiler but he did! I knew when I seen it at Dads that I had seen it before and when you said you worked at Murdoch I put one and two together. Although you spend all day on here so I dunno when you are actually working. How many lectures do you give a week? One?

Originally posted by GTS-t VSPEC

Dave,

Yeah, Micko and I are both short, but at least I have gone grey yet like him:D

See'ya:burnout:

Give it 12 months and you will be grey with a bald patch in the middle!!!! You are 24 after all!:shake:

Guest
This topic is now closed to further replies.



  • Latest Posts

    • It says 300ZX, does that make it an Aus delivered car? Funny how back in the day I just couldn't care less about Z32's and these days I am just in love with them. Back when Nissan was into pushing the envelope. 🤣
    • Hi guys, just after some guidance with an R34 sunroof that has stopped working correctly. It still opens and closes perfectly fine, but it no longer tilts/vents up or down. As a result, the rear of the glass now sags a bit as it drops down slightly in order to retract into the roof, but now it can't pop upwards into a flush position. I’ve probed the pins on the back of the switch connector with a multimeter and it seems like both switches (for open/close and tilt/vent) still work correctly. Any ideas on what it could be, or where I should even start in terms of diagnosing? I'm sure someone's had this issue before but I haven't been able to find anything online relating to this specific issue, most of the issues are with the seals leaking or the motor failing entirely. Thanks in advance!
    • Do you have some data like fuel pressure? It's really hard to say if you're still fighting a fuel system issue at this point. Could be something weird like the FPCM dipping out.
    • Yeah in that case, pulling the dent out. Event a very slight dent can create a lot of work filler-wise and there is a strong chance the panel won't be the factory shape when you are done (as the dent will result in a new high point created somewhere, then everything is brought up to that new high point... but the panel shouldn't be that high if that makes sense).  So you've filled and primed the panel and it is flat, why would you go back and remove the primer and add more filler? 
×
×
  • Create New...