Jump to content
SAU Community

Recommended Posts

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by GTS-t VSPEC

Thankgod it's not targa, don't feel like pulling the GTR out of a tree:p

See'ya:burnout:

There are trees at Wellington dam so don't speak too soon.

cheers

Ken

Originally posted by GTS-t VSPEC

I think she's staying there too, that way we don't have to get up so early:D

See'ya:burnout:

Huh ??

If you stayed at home you would get an extra hour sleep.

Mickos is 35mins from my place and you had better be here at six

Takes 3 hrs towing and MUST be there by 9.15 at the latest.

Cheers

Ken

Originally posted by GTS-t VSPEC

Ken,

Well if Frank Ferrari can roll Ray's car on a straight bit of road then anything can happen:bahaha:

See'ya:burnout:

It was straight alright, straight thru a T Junction and over a bank

Cheers

Ken

Guest
This topic is now closed to further replies.



  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...