Jump to content
SAU Community

Recommended Posts

Originally posted by skyzerr33

hellos

tzars all worn out

and hes dissappointed no chicks to pick up tonight r well always tomorrow

Tzar ?? that's a strange name for your willy , Willy. Hehehe

Cheers

Ken

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

hehe good plan Sneeza :P my mum taught me that one - she uses it a lot on dad - say yes dear and do your own thing anyway :(

Nah dont want anything crazy psiker - my cars pretty standard and dont want to inject too much into it if its not yet equipped to handle it - but i want to put more into it than what its currently injecting.

Originally posted by caminperth

psiker - check my post in the wa section - may be able to make ur car go faster.. :P funny as hell - tho you may have seen it before...

im reading it now mate :( hoping to pick up some tips :)

hehe im gonna get flamed but i actually think it is a pretty pimp looking car

Psiker

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...